OK so here is my problem, after my 04 cobra warms up it gets really hard to shift, even just cruising around, and this just happened over night and i had not been driving it hard lately. crazy part is when its cold it drives completely normal. but after it gets fully warmed up, or worse gets...
ok so im trying to get the timing tensioner dowel pin for the 03 iron block, is the part number i need
YR3Z6K282AA or N806040-S time is an issue on this one i would really love some fast feed back thank you:)
I found this add for two teskid long blocks, i thought its a good deal, i dont need it but im sure someone will.
96-98 cobra long blocks for sale 4.6 DOHC - $600 (point loma)
Reply to: [email protected] [Errors when replying to ads?]
Date: 2009-04-19, 4:10PM PDT
i...
I found this add for sale, thought it could help someone out if they wanted them.
96-98 cobra long blocks for sale 4.6 DOHC - $600 (point loma)
Reply to: [email protected] [Errors when replying to ads?]
Date: 2009-04-19, 4:10PM PDT
i have two 4.6L DOHC long blocks...
K guys, i have a 2004 cobra with 27k miles, this last weekend i had a pulley installed and tuned, by Greg and RET, two days later after doing nothing special just jumped in the car to go home after the car had been sitting for about 8 hours, and I'm getting knocking from the passenger head, its...
just got back from the Dyno after getting my car tunned. my set up is flowmaster cat back, JLT Carbon fiber CAI, tr6 plugs gaped to .32 with a 2.76 pulley w/90mm idler pulley, SCT tune by RET and i pulled 472rwhp and 486rwtq.
i thought thats perdy dam good for this set up.
I heard roomer that mustang dyno's hit about 15% lower than a dyno jet, i knew they hit lower but i didnt think it was that much, any input on the matter? is this true? 15% about right?
im about to put a JLT CAI, 2.73 pully and belt with 90mm idler pulley, with tr6 plugs. will the stock fuel system support this? and is there anything else i need to have done for this build besides a good dyno SCT tune?
Im new to the terminator world and i had a question that is prolly stupied but ima ask anyways. I just bought a 2.73 upper pulley and 2.73 pulley belt do i need an idler pulley with that or will it work fine without one on the no slip pulley? as well, i never heard of a 2.73 pulley before, only...