Well all I can say is, its been an expensive and uncomfortable journey in my short term ownership of my 500/500 Terminator! I could not get use to the lowered handling, bumpy, noisy engine and ride, I have been too spoilt with BMW's and co. The car was very fast which was the desire factor but...
Driving home last night and got pulled in my new Terminator which I have had for a little less than a month and the cop gave me a ticket with court appearance as I was doing 30mph over the speed limit! My bad I know although it was whilst I was overtaking a car on a toll road and 30mph was only...
I have a 2.8 upper and 2lb lower, I am in need of a new pulley belt soon and need to know what size and where to get it from?
Any advice is appreciated.
Thanks
Hi
I am currently running a 2.8 Upper and 2lb lower, I am thinking about changing my pulley's for better ones. Especially the idler pulley as it squeeks and I would hate the pulley to fall off (had this happen to me on another car and it was not pretty).
What are the reccomendations on...
Today i started my car and heard squeeking coming from the pulleys / belt below the blower, my 2.8 was fine it sounded as though its coming from below. Does this mean I should change my belt or pulleys? I am running 15psi on stock pulleys apart from my 2.8 upper and 2 lower.
Thanks
I am thinking about changing my clutch soon and hate the heavy and long pedal, I want the lightest and lowest possible solution.
I have a steeda FW adjuster but really want a light clutch because I am always stuck in heavy traffic when going to work and back. Yesterday there was a 2 mile...
Does anyone know where I can buy a half cover such as the ones being sold with http://www.lethalperformance.com/pages-productinfo/product-13237/jlt-rai-fmc-0304-jlt-03-04-cobra-true-ram-air-intake-complete-kit.html
I am looking to keep the warm air away from my 12" cone filter which is on the...
I am thinking about buying 2 new rears in 295 35 18 and I have seen the Toyo's for $200 online. Has anyone run these? What are your experiences with a Terminator?
Took these after some cleaning, alot more needs to be done. DD so it will be getting dirty every week. The car is awesome for 3rd gear rolling burnouts :rolling:
I have a Diagostino tune on my Terminator which is awesome, however when turning in 1st gear or coming to a stop the car stalls which is driving me mad.
Also it's very difficult to cruise around town unless I have the throttle more than normally open, either its on or off to be able to drive...
I currently have H&R Springs and the car wobbles from side to side when on boost and above 60mph onwards if on power. Then above 80 there is vibration coming through the steering wheel, I have had all 4 tires balanced and checked so no issues. There is also 3/8 spacers on to clear the IRS Bolt...
I am thinking about http://cgi.ebay.com/ebaymotors/1-NEW-295-40-18-Falken-Azenis-RT-615-Tire-40R18-R18-40R_W0QQcmdZViewItemQQcategoryZ66476QQihZ010QQitemZ200142731366QQrdZ1QQsspagenameZWD1V
But not sure if my 10" FR500 Rep wheel's will take these on a Terminator? I don't want to mess around...
Happy Thanks Giving! :banana:
http://www.uprproducts.com/shopping/shopexd.asp?id=1078
They say it makes the clutch pedal shorter as I am looking for an easier pedal feel, I already have the steeda adjuster but want a smaller clutch pedal as driving in heavy traffic is boring me.
Thanks