Recent content by nik96

Stock 5 speed that it came with, 6 puck clutch, rear disc 8.8 from an Explorer and a dana 30 from a wrangler up front. The 2.3 is sleeved, JE pistons, Crower rods, ranger roller cam, ported head, T3/T4 choo choo and e85. Salvage title. lol

Stock manifolds, routed pipes up and around the frame, then back down under the rockers. The gates used to stick out of the hood. Looked badass but was too loud so I recirculated them. Sent from my iPhone using Tapatalk

Stock 6.2. Twin PTE 6262 with meth. I made the kit.

Sent from my iPhone using Tapatalk

Sent from my iPhone using Tapatalk

Sent from my iPhone using Tapatalk

Sent from my iPhone using Tapatalk

I'm trying to find the distance from the back bellhousing mounting surface of a 302 block to the outer surface of the flywheel(fox mustang) where the clutch mounts. Doesn't have to be exact, within .050" will probably cut it. If anyone has a Block out of car with a flywheel bolted up to the...

We have a winner!

(Colorado) A few days ago I was pulled over on the highway(US-36) in a 55mph zone while doing 51. It had snowed earlier that day and the roads had been plowed and sanded. The particular stretch where the violation took place was, in my opinion, clear with snow drift on the shoulders. When I...

I have read a lot of different opinions and write-ups about the proper m/c and booster setup for fox cars with 13" cobra front calipers and sn95 GT rears. I am on the fence about hydroboost but I'm not sure what my traditional options are. It would be pointless to have upgraded brakes with...

Hey guys. Getting ready to rebuild my 8.8 from a '95 GT with moser 31's and an Eaton with new bearings and gearset. Never been in an 8.8 before and just thought I'd see if anyone's got a decent write up link on a good build. Also any suggestions on diff covers? :beer::burnout:

Got your stock gears laying around? Looking for a cheap set. I'm in Denver, thanks.:beer:

So I assume the classifieds went away...? Anyway I need a used 3.27 gearset if anyone if anyone has one. Not sure if it's ok to post this but I thought I'd try. Let me know if you got one, thanks.

Hey guys. having some fitment issues with my rack to the UPR K member. The rack bushings don't fit over the tubes on the K member and the original '80 rack bolts are too large in diameter to go thru the K member... I've been searching for a bit and cant find a discussion of the correct rack...