I have an 03 tenth with 63k stock motor. It has had the basic bolt ons since i bought it at 30k. Im looking to get to the 650+ range so i dont want to buy anything that will restrict that later. E85 is very prevalent in the chicago suburbs so that is the direction. I just put in at spec3+, 26...
Takin it out today after new clutch and input shaft install resulted in a grinding 4th gear. Would like to freshen/strengthen it up. It has 60k. Any suggestions? Thanks
Hey guys, Last week I installed a spec 3+/flywheel/pilot,tob, lethal retainer/26 spline shaft. All this was after the stock tob and sleeve failed at 60k. Now after getting the car back together it wont go in 4th gear over 25mph or so with out a bad grind and gets worse the faster you go. I...
I have been searching for a set of rotors to replace my stock fronts and maybe rears and I keep wondering if the rotor deals on ebay are any good or a problem waiting to happen. Does anyone have any experience with these drilled/slotted rotors all over ebay? they are about 60% less then brembo...
about 2 weekds ago i had an idler pulley break and it broke my belt, but everything else was fine, and the car still drove home. I replaced all the idlers with reichard idlers. And i got a Gates belt. I have a 2.76 upper and stock lower. The new problem: When i start the car for the...
Hey guys, im putting in my new RR idlers and I dont want to over tighten them but i also dont want them to come lose. Any thoughts on how tight to get these allen headed bolts, Anyone use loc tite on this? Thanks in advance
Hey guys, The last week or so i have been hearing a squeak type noise from the front of the motor, belt area, so i took the blower belt off and started the car and it the noise was gone. I put it back together and noticed the lowest idler was lose, and i thought great thats it, im glad i found...
I am the second owner, i bought the bike with 650 miles from original owner.
3600 miles
Integrated rear signals, custom license plate bracket (Looks Clean).
Flush front signals
A&R motorsports exhaust. (looks stock, sounds awesome.)
Puig Black windshield
Still on original tires with plenty...
Hey, I just got a bassani x pipe and i cant get the nut off the stud on the passenger side downpipe/manifold. Its a bitch to get to, anyone have any ideas or advice. Im going to go crazy, this has turned into an all night project that should of taken an hour. Any help appreciated, but if i...