Recent content by modforce

I am needing the shifter bezel and boot, door bezels both sides, door handle bezel, gauge cluster bezel, radio bezel for 94-98, so anything from 94-04 as long as it's black or charcoal.

I have a complete running engine out of my 96 Cobra. Engine does not smoke or burn oil at all. The heads have had a 4 angle valve job done on them and resurfaced which helps in raising the compression to 10.5-1. The heads have new lash adjusters installed as well. I have receipts for work...

I am looking for some cams for my 96 Cobra. I will be selling my stock ones and keeping stock springs if possible. Let me know what you have!

BBK High Flow Cat H-Pipe...SOLD Sold.

Well I finally picked up my heads today!!! Valve job looks great. I asked the shop how much for them to degree my cams for. They said I need adjustable cam gears. Is this correct? I have a 96 Cobra stock heads with the exception of valve job and milled down. They told me to just line up the dots...

Will I have to get a tune if I do the egr delete? I am looking to go with headers and it would be easier to not use it!

I am thinking about putting longtubes on my car. I have the heads ready to go back on and the block is in the car. Will this be a pia with the block in the car and the heads off? I am on a very tight budget and are they really expensive when I look at the headers, then mid pipe. So with that...

I am looking for a set of Lng Tubes and off road x-pipe to go with them. Any one have any that would like to sell. They are for a 96 Cobra B-heads.

I am possibly looking at rebuilding my 96 Cobra engine. I am on a budget but wanted to go forged internals. What do you all think about the pistons that come with this kit. It will not see alot of track time but might see it from time-time. I am shooting for a good DD but want power to go with...

I am looking for a set of LT's and x or h or prochaber for my 96 Cobra. Trying to stay in budget here and don't want to spend alot but will buy quality. Let me know what you have. Thanks.

I am having a set of B-Heads milled down as they had a slight warp. They are taking 16 1/2 thousandths off the heads. How much will this raise the compression on a stock bottom end?

It is worth doing a valve job on a 106K mile motor? Do you pick up any power by doing a valve job? I havea few different prices between a 3 angle and 4 angle. Any advice? It's for a 96 Cobra B-heads

I have ran across a deal on a Paxton Novi 2000 SUpercharger. But it is for a 2001 GT. Does anyone know if this will work on a 96 Cobra? I can get it for a great deal and it is a low mileage unit as well. It has nothing wrong with it that I can tell. The guy has all the bolts, brackes, couplings...

I have a 96 Cobra I just bought and the bottom end is still together but the heads are off the motor. Car was getting hot I was told. I am not sure if they burped the motor when they refilled the radiator as the person who owned the car does not know much at all about motors. I am going to have...

I am looking for a Cobra in and around the Cincinnati, Ohio area or willing to drive as well. Trying to keep it under 25K with or with mods. My email is [email protected] if you should have any.