Recent content by metaman

SOLD Will post more pics on this thread over the weekend. Rain stopped the photo shoot. Body is as clean as it looks. No door dings. Plenty of touch ups here and there, it is after all a 10 year old car. Zero smoke on start up and wide open throttle. Breaks the tires loose from a 40 roll no...

Need to get my hands on a good stock mass air meter. Text to 561-644-8087

Just doing some diagnostics to figure out some idle and part throttle roughness. Fixed a massive vacuum leak and reset the fuel trims (battery disconnect) Played the musical ignition coils game and no change at all. Pointing now towards the mass air. Mostly because when ever it is...

Is the upper seat frame in a Terminator Seat the same as the seat frame from a normal Gt mustang? I am asking because my upper seat frame is broken and I am planning on swapping over the foams / bladders / covers to another seat frame.

My upper seat frame on the drivers side is fugged up. It must have broken metal in the right side of it. Does anyone know if the seat frame of the cobra seats is the same as the normal gt mustang seats. I looked at a buddies the other day and from outside appearances they are the same, hard...

I have owned this car for 8 years and 125k miles. This is the first time that it has done this. The strange thing is that when it first started it was intermittent. It would do it for a few days, then suddenly it would be gone for a day or two. At part throttle only (runs fine under...

I have been running a Fidanza aluminum two piece flywheel on my car for about 55k with a centerforce dual friction clutch. I am planning on putting the same clutch back into the car. There has been no incidence of glazing. Do you guys think I will need to put a new friction surface on...

My car has been doing this for about 2 years and I gave up on trying to figure it out. It is not a huge issue, but is is annoying. When ever it is below about 55 degrees it stumbles when you give it gas for about the first 90 seconds after you start it. I usually just wait for it to warm up...

Just like the title says. I want to purchase a low mileage stock intercooler tank. I know there are a bunch of them sitting around out there. PM me or send me an email at [email protected]

I bought the 03 cobra new and have daily driven it ever since. It has got 107K miles on it now and runs and handles better than new thanks to the subtle mods done to it by me over the years. I am starting to become some what over the whole excitement of the car. Yes, it will run high 11's...

I do not currently have a Killer chiller however I have been reading all of the Kincade Killer Chiller threads. There where multiple mentions in these threads about the increase efficiency of the Enviro Safe R12a industrial refrigerant over the r134a. I checked and it was pretty cheap to buy...

Both of my power windows work fine at night when the ambient temp cools down, and then during the day after the car has heated up in the sun one or both will refuse to go down. Sometimes I can click the switches back and fourth real fast and they will free up and work fine. They are not slow...

While doing research through the forums about the boost bypass actuator I discovered some things that are important for terminator owners. It has been debated over and over about the boost bypass modification that prevents the boost bypass actuator from bleeding off extra air when not in boost...

:shrug: I bought the Reische Thermostat and I am going to put it in tomorow when I change the coolant. Where is the thermostat?

I have the steeda quick ratio quadrant. The pedal effort is still low with the centerforce DF. I would like a quadrant that gives me even quicker leverage than the steeda unit. Does anybody make one. It would really make speed shifting much easier. I would like for it to be about 25 percent...