MalcolmV8's latest activity

They're still around. The original author doesn't have a terminator anymore but he's still into cars still around. I have access too...

No I ran that all of 1 day, maybe 2. I did not care for that restrictor setup. Even so once the bypass was closed you got all the...

That's impressive. Mine have never been anywhere near that. I see I posted about half up above, I'm thinking it was less than that...

Yes I went from a 2.9 Whipple to a 2.3 TVS on the Zinc and absolutely love it and would never go back :) lol I was running a Gen 2 2.9...

I sent you a PM

The crusher inlet rubs on the hood but you can create some clearance. Here's how I did it some time back. Here you can see area marked...

I did not try different cylinder finishes with the gapless rings. They were seated and sealing very well as are yours. I actually got...

I feel your pain. I'm sure it's up in this thread from years ago but Total Seal swore by those rings and had me doing all kinds of work...

Not at all, it's good someone answered. The thread is what 7 years old lol, valid concern.

Yup threw those gapless rings in the trash and never looked back. After all the tear downs, rebuilds and attempts at making them work...

Hi Mark, I don't have a blown inverter for you but I've enjoyed the thread. Great work and I look forward to what you figure out and...

The man, the myth, The Legend…@CobraBob! His webpage was the first one I went to back in 2015 when I finally got my Cobra...

Sounds like the exact same design sensors I'm running. I have one on each side of the block. It does sound like yours is responding...

Oh ok. Doesn't the factory sensor have a stud sticking out and requires a boss to turn into? Normally in the valley of the block...

What settings do use on the knock sensors and how have your found their performance? I've played with the knock sensors quite a bit and...