Recent content by Logans06

03 Blk 600hp Cobra, CCWs, 28k miles, fully built sold Im looking to sell my Black 03 Cobra, the car has 28k original miles on it. It was recently just built in Memphis, Tn at Dynospeed Racing. It has a brand new MMR stroker engine and was dynoed at 598rwhp/545 torque on 15lbs of boost. The...

I have a cylinder down in my cobra due to too much timing and boost, so Im gonna go with a MMR shortblock and Im running stock heads with the kb 2.2 Car made 650rwhp on 22lbs and 21 degrees timing with a 3"upper and 4"lower on the stock shortblock. Ive been looking at the MMR 5.0 Stroker Mod...

Well guys I, just done a compression check on my 03 cobra and one of the cylinders is only holding 20psi. Im pretty sure the rings are shot on that cylinder. Im running a 2.2 kb with 21psi. The car dynoed earlier this year at over 600 rwhp. So now Im looking to get a shortblock or have mine...

I had my car dynoed and ran some diagnostics on it yesterday at a performance shop. Im running a kb 2.2 with supporting mods on a stock block, 3 inch upper 4 inch lower. Car makes about 21-22lbs of boost. I am running 23 degrees of timing on 93 octane pump gas. At WOT the air fuel was about...

I recently just purchased a 03 cobra with quite a few mods, and my autometer water temp gauge does'nt seem to be working. The lights work in it so its getting power. It is an electrical gauge so, does anyone know where the sending unit is located or have a suggestion? Its a Lunar series gauge...