Recent content by kcsburk

Steeda CAI and SCT X3 for sale $450 shipped Steeda CAI is cleaned/oiled and ready to go SCT X3 is unmarried and ready to go. Will come with Steeda 93 tune and Steeda 93 cammed tune for a 2012 Mustang GT

I have tried so many exhaust setups and this is the best of all I have tried so far. I have since replaced the OR pipe with a catted pipe. Car is still about as loud but less raspy on the deacceleration part. Unfortunately, there is a good difference in power between the OR and catted pipes:(...

Kooks Axle back for 2011+ Mustang GT 5.0 Brand new condition...only a few days old. $450obo shipped....Save $150 over new

Magnaflow Catted Xpipe for 2011+ 5.0.....Like new condition $800 new....$500 shipped

I swapped the Corsa's for a Kooks setup. How do you like the Kooks setup compared to the Corsa's? The Corsa setup is much louder but gets a bit raspy in the upper rpms. The Kooks setup has a much cleaner sound but has a slight drone and a deep base sound at low rpms. I am adding long tubes...

Got it all together. What do you all think. UIazoCOwWRQ

I am looking to trade my Corsa Extremes for the following axle backs. Any trade must be in like new condition without any flaws. I really want the Kooks setup but will consider the 2nd and 3rd choices. Not interested in any other exhaust setup. My Corsa's are in like new condition. 1...

My car has the P-Springs on it now. I want to go a bit lower. If you have sportlines or k-springs installed(and settled), can I get you to measure the ride height of the front a rear(floor to bottom of wheel wells)? My P-Springs measure: Front - 27.5" Rear - 28.5"

Looking for a 2011/2012 low mileage race red Brembo car with 401a package.

My car feels very sluggish down low. I would like to know if this is normal for a car with only a cai and a catback? If not, how can I figure out what is causing the problem. After about 2500rpms it feels OK for the mods I have but below 2500rpms its a slug. What other solutions are...

I am trying to find out what the distance from the ground to the bottom of the fender with H&R SS springs installed. If anyone has these measurments I would appreciate if you would post them. If you have a Cobra with H&R springs would you mind taking a quick measurment and posting them. I am...

The install took about 30 minutes which includes wiping everything down for pictures. No real rocket science involved to get the RAI installed. It is a tight fit to get the filter in but like I said not really any rocket science involved. I did not pay attention to how the MAF was positioned...

Does anyone here have any experience with either XM or Sirius running from the factory head unit? I found a kit for each at the below links but there is not alot of information on the Cobra forums about installation, etc. Sirius - http://www.radiosandmore.com/prod_detail.asp?pn=4047453...

I have the AFS 10.5" wheels on the back of my Cobra and the passenger side sticks out about a 1/2" further then the drivers side. My car is lowered quite a bit so its really noticable. Does anyone make a device that can be used to center the rear end correctly? Thanks, Chris

Hey, did any of you who changed your shifter out have the little plastic basket that goes around the ball on the bottom of the shifter? I have always had one on all the other mustangs I have owned but did not see one when I took the stock shifter off. Thanks, Chris