Recent content by JQADDINGMACHINE

It's just a schrader valve stem cap. I'm sure any local tire shop would give you one for free.

I have a factory heat exchanger and brackets but no hard lines. Best way to reach me is 302-993-6615 I'm not on here too often to check PMs.

I had a PA performance 130amp alternator in my eaton swapped 96 cobra, and one day the battery light came on and it wasn't charging. I was still under warranty so I sent it out to PA peformance to have them fix it, and if I recall, I had it back within a week and a half (but they never told me...

1996 mustang cobra 180,000 miles It's been parked for around 2 months because an IMRC cable broke and I never got around to fixing it, but I just put some new plates and a controller in it yesterday. I got it all assembled again and when I started it up there was a HORRIBLE knocking noise for...

above 6000 rpm i can hear and feel it sputtering or cutting out and i'm thinking fuel pump might be getting old and weak and not keeping high enough fuel pressure at WOT high rpm? I don't want to buy a pump unless I'm sure it's the problem. heres a video...

Hello! I've got a Crystal White 96 Cobra coupe, and I have a few questions about what I should do to the car. Mods that came on the car: BBK O/R X pipe Mac Catback BBK 62mm TB (I've heard this can actually hurt performance, opinions?) Short throw shifter (no idea what brand) BBK rear...

got a code for IMRCs stuck closed so I figured i'd clean them the IMRC valves themselves look almost spotless, but the ports in the heads or whatever that the IMRCs open up are incredibly dirty and gunked up compared to the other side: is this normal? whats the best way to...