Recent content by Jon

  1. Jon

    How difficult to repace steering shaft and rack bushings?

    I am considering going with the MM aluminum rack bushings and the solid steering shaft. How difficult are these to replace. I took a quick look and it looks straighforward. Are there any "gotchas" with these upgrades? -Jon
  2. Jon

    Whipple and 91-octane??

    Is anyone running a Whipple supercharger with 91-octane? I was wondering what the maximum practable boost is for California gasoline. Does any tuner even offer a chip for this combination? Thanks, Jon
  3. Jon

    MSD Stacker - don't bother

    About 10K miles ago I installed a MSD Stacker on my 2003 Cobra. Reference link: MSD Stacker installed To date I have not been able to substantiate any gain in power or mpg. I was hoping the MSD would help address the stumble my car has with tight (.035) plug gaps but there...
  4. Jon

    Buzzing noise near kick panel, what is it?

    Every once in a while I hear a buzzing (maybe rattling?) noise near the drivers side kick panel. Maybe something behind there is loosly mounted. Anyone have this problem? -Jon
  5. Jon

    Who can install Subframe connectors in San Jose, CA?

    I work in San Jose and am looking for a shop that can weld-in a pair of subframe connectors for my '03 Cobra. Any recommendations? The place local to my work quoted $400 in labor. Seems high to me. -Jon
  6. Jon

    A better location for the XM antenna

    I have finally installed an XM system in my car. I was at first reluctant because I was really turned off by the ugly black wort of an antenna that I had to place on the roof. However, I tried mounting it right next to the stock antenna on the passenger-side fender and the reception has not...
  7. Jon

    Does our oem ignition have multisparking?

    I had heard that a number of Ford OEM ignitions are multisparking, is ours?
  8. Jon

    What does belt slip sound like?

    I was driving down a back road this morning to road test the MSD Stacker. At WOT and about 5500 (in 3rd gear) a loud sound is heard from underhood and the power hits a plateau. It almost felt like it would not rev any higher but I was running out of road too soon to know. Boost peaked at 13.2...
  9. Jon

    MSD Stacker installed

    As far as I know, nobody has tried installing an MSD stacker on a Cobra yet. I installed the stacker because I was curious to learn if it would help the rough running. My car is has a 2.93 pulley, chip, Steeda CAI, and Bassani exhaust. Like a few other Cobras, my car either misses on the low...
  10. Jon

    Anyone install the MSD stacker yet?

    Just wondering, looking for a review.
  11. Jon

    Where is the ignition module?

    Where is the ignition module on this car? I am trying to trace back the coil wires but I get lost in the maze of wire harnesses.
  12. Jon

    Need advice for first suspension mod...

    I do a lot of driving on the twisty mountain roads and after 30k the Cobra's suspension feels vague and somewhat out of touch with the road. I am hard on suspensions and every car I have owned begins to "loosen up" after about 25K. The Cobra's suspension is less than confidence inspiring...
  13. Jon

    Anyone try the MSD Stacker-8 yet?

    I noticed that the MSD Stacker-8 is finially available. Has anyone tried one yet? -Jon
  14. Jon

    How to mount amp to back seats?

    I've seen a few pics of amps mounted to the (trunckside of the) back seats but I am not exactly sure how they are fastened. Do you screw a mounting board directly into the seats? Where? Can anyone elaborate on the details of their install? Thanks
  15. Jon

    Is the KB ready for daily driver use?

    Now that the KB blower has been out for nearly six months (maybe more?) what is everyone's opinion on the reliability of the unit, for moderate boost levels? Are these blowers ready for daily driver use?

Top