Recent content by johnnyrambo41

FS-CT- 1994-2004 Mustang Maximum Motorsports front control arms Std, Non offset, Urethane. Part#Max-MMFCA-7 Asking-$300 buyer pays shipping. Hypercoils- part#HYP22509225, 9''x 2 1/4'' 225lb rear springs. Asking-$80 for the pair, buyer pays shipping. Afco front coil...

FS- CT- 1994-1998 Saleen S281 rear spoiler. Wing is primed in black gel coat, ready for prep and paint. Bolt on replacement for stock rear spoiler, uses factory mounting location. Asking $100 shipped.

FS- 96-04 Mustang GT/Cobra BBK shorty H-pipe with High Flow Cats. BBK Part #1538 Brand new in Box. Asking $350 or best offer. Buyer pays shipping. Located in Brooklyn CT.

1998 4.6 cobra 4V Looking for suggestions on the following: a good performance water pump (non-electric)? was thinking of running the mishimoto race stat (154* if my celsius conversion is correct 68* celsius)? and some form of water wetter? i'd like to hear what you all think...

Anyone know what part# motorcraft plugs for 98 cobra 4V? BAMA told me to get the cheap copper core ones (said less chance of pinging pre-detonation), but all i can locate are the platinums? The only ones i can find say copper core platinum tip, will these work?

Looking for some advise on a few tuning issues, I bought an SCT tuner from BAMA w 3 custom tunes... lets just say my cobra did not respond well at all, (sounded like it was pre-detonating/ pinging. 98 4.6 4V, long tubes CAI O/R x pipe etc... i sent a few datalogs to BAMA but they dont seem to...

Here goes, 98' Cobra, MMCO-2 coil over kit tokicos all the way around, just doing the front coil overs for now, the rear will stay with the steeda drop springs. Car is a new england (shitty roads) driven car, anyone suggest a good spring rate, want the car to be on rails but not rattle my teeth...

Ok, heres the situation, i was quoted $650 to modify my staock B lower intake, which seems ok, but i also have to figure in the IMRC deletes $230, gaskets and my old intake as a core (which is gotta be worth $300), so at this point im at more than what MMR charges for their RTS manifold $1200...

Can anyone post pics of the installed steeda subframes#555-5245 especially the transmission crossmember bracket modifications, i dry fit them today and was a little disappointed, steeda said only minor mods would be needed to fit these in, but from the way it looks I'll have to completely rework...