Recent content by jlutz

.

(1) MGW T56 shifter - 2yrs old. Used for 5000 miles. Works fine. Handle too short for me to reach with seat back. $145.00 shipped (1) Fiore Quadrant only. Used about 100 miles. Like new! $29.00 shipped (1) Max Motorsports Quadrant. Used about 5 min. New $24.00 shipped Email is the...

Have some stock '03 Cobra stuff laying around that I don't need in case anyone is returning car back to stock. All parts were taken off at 25,000 miles. -Stock flywheel- $55 shipped -Stock pullies (3)- $40 shipped -Stock lower pulley asm w/ removal tool - $ 45 shipped -Stock TB - $30...

I bought this from Lethal Performance but never used it. Here's their description: LP-T56TOBSLEEVE This is a must for all when doing a clutch swap. As most of us know one of the weak points in the 03-04 Cobra T-56 is the Thowout Bearing and it's sleeve. Most of the time the TOB will go bad...

$100 shipped to lower 48. Injectors have 25,000 miles on them. Taken out of my car when I switched to KB & 60lb injectors. PM or email [email protected] if interested.

This was on my car for about 12,000 miles then it was replaced with a KB cold air kit. Paid $139 new. $80 shipped.

I have a KB so I don't need this anymore. Used once. Paid $179. new. It can be yours shipped for $100. Thanks !

I found one other post about cutting a wire but I went about it the long Rube-Goldberg way using info I found on Mitchell. A bunch of stuff (one touch window,wipers,int. lights, & warning chime) is controlled by a generic electronic module (GEM) located next to the fuse box near the clutch...

Just curious if anyone has experience bearing failure on their Billetflow pulleys. Mine are 1.5 yrs old, with 20,000 miles on 'em and just started making all kinds of noise. I took them off, and slowly spin each one on my finger they have definate flat spots on them and bind up. I actually...

New 03-04 Cobra IRS Magnaflow Catback. $479 shipped to lower 48 states. Thanks!

I bought this, opened it, but never used it. Ended up getting my car tuned on the dyno. $150 + shipping.

I just upgraded to a KB 2.6 and no longer need my ported Eaton. It's the stage 4 port with plenum (not ported) and 2.76 Billetflow non-slip interchangable upper (black). The blower has about 12,000 miles on it and has always worked just fine. Asking $875 shipped. PM with questions and I have...

test

I'm curious what work has been done on my car. Especially regarding the heads. The VIN is 1FAFP49Y23F392847. Thanks,

I finally took my car to the track since it was cold Wed. night. Got three runs in with 12.1 @ 116 (2.0 60') being the best. Had a heck of a time launching well with the 315/35/17 Nitto 555R's at 20lb. I powershifted every gear and it hooked ok once I was past 2nd gear. I smelled the clutch...