Recent content by JCam550

Updated mods and numbers Supercharger: Posi Ported Eaton RWHP: 526 - 93 Torco RWTQ: 505 PSI: 14 Timing: 24 Upper : 2.76 Lower : Stock CAI: JLT TB : Accufab SBTB MAF: SCT 2600 Injectors: 80 lb Ford Racing Fuel System: Stock w/ KB BAP Header: Stock Mid: Bassani X w/ Hi Flow Cats...

I just put a McLeod street extreme single disc and a lightened steel McLeod flywheel in. Pedal is nice, light and smooth compared to the Spec I took out. Sent from my iPhone using svtperformance.com

The dual fpdm harness is all set to just plug and play a second fpdm? I'm upgrading and trying to figure out the best route to go. Also does that hat accept the stock fuel line? Sent from my iPhone using svtperformance.com

These still available? Sent from my iPhone using svtperformance.com

Very nice car. I actually like the wheels. Something a little different from everyone else.

Just ordered a clutch and flywheel!!!

Add me to the list of people. I'd like to sign it. Great book!

Welcome and congrats on the purchase. Mass member here as well. There are some good groups and some great shows in MA and NH. Throw a smaller pulley and an intake on it and visit Pete at Performance Dyno and it will wake up the beast!!

Same here. Here is mine done recently. Slight drop over 5k.

Here's mine. Bought last august. 65K miles. Massachusetts

Supercharger:Stock Eaton RWHP:489 RWTQ:516 PSI:13 Timing:24 fuel:93 upper size:2.76 lower size:stock CAI:jlt MAF:Stock TB:Stock Header:stock mid-pipe:Bassani cat-back:Borla Stingers transmission: t-56 cams:stock head porting:n/a shortblock/compression:stock dyno type:dynojet tuner: Pro Dyno

You looking for the oversized one or the small stock size canton one?

I feel your pain! I bought a beautiful 1993 Notch with a built 331 and a vortech. Kid told me the head gaskets had just been done right before I bought it. (That should have turned a light on in my head). Take it to the dyno and check the tune. Put up just shy of 500 rwhp (he dumped out...