127mm jlt carbon intake
Ford cobra jet mono blade TB
NGK TR7 spark plugs
Kooks 1 7/8 headers with off road X-pipe
Upper pulley
Corsa exhaust
It was 106 degrees in dallas today that it did ok for how hot it was
722hp 708tq...
Took to dealer ship cause misfire they changed the plugs drove it for a week check engine light comes on for misfire car starts to run like crap I decide to check the plugs and this is what I found then did a compression test and had little compression on driver side of motor.
I was in 4th gear running about 160 and the engine light came on and was flashing started to slow down then it went off around 60 . I pulled over and plugged in the programmer and check for any codes and nothing showed up never happened before any ideas what could cause this or how to find out...
2013 GT500 - Dyno at Dallas Mustang - YouTube
2.396 Upper Pulley
made 732rwhp and 711tq
now before you can see the dyno made 730hp and 667tq
and that is 127mm jlt TB kooks header and x-pipe
only gained 2hp but 44tq?
Went to the track last night for the first time with the car. Launch it around 3200. It spun like hell through first and second but after finally getting traction half way through second it hauled ass the rest of the way.
Needs DR bad.
What size of DR and kind is everyone using on there car??
Was wondering what dyno numbers people are getting with there mods.
This is what I done to mine.
127mm jlt carbon intake
Ford cobra jet mono blade TB
NGK TR6 spark plugs
Kooks 1 7/8 headers with high flow cats
Dyno numbers are 730rwhp and 667 torque
On 91 octane
Torque seems low...
looking for some help on whats the best tire to put on. The factory tires suck for traction after mods. What tires do you all recommend for the 2013 shelby. and looking to get a set of track tires to.
I have a 2013 Shelby gt 500 and on the rpm setting launch control I can only change mine from 3000 to 4500 I have talk to some people and watch some videos and I have seen people from 2500 to 5200 is there a way to change the rpm setting beside in the rpm setting can anyone help me
Launch control rpm settings on 2013 Shelby how can you get it to go below 3000 rpm my only goes from 3000 to 4500 I have seen videos of some going from 2500 to 5200 and people talking about it can anyone help me please