Recent content by HPCobra04

Can you purchase anti rattle clips for the front brakes? My front brakes rattle like crazy until I apply the brakes.

Anyone ever have noisy/ratling from the calipers. Mine rattle their ass off until I use the brakes. Went to the dealership and confirmed that some of the clipps were on wrong so they tried to fix(no charge) and use anti rattle grease. Itg helped a little bit but the still rattle bad...

Ok Im going to end up pulling my hair out. I have a 2.76 upper 90mm idler 9inch lower. How the hell do I figure out if all my pulleys are lined up right. So sick of going through belts. someone mentioned scuffing the outside of the belt. Hell im about to give up.

Tried going over this before and got a new Napa V belt 4080780. less than a thousand mile later squeeling its ass off all the time. Looked at metco site and it suggested that I look at my tensioner and make sure the mark is lined up properly and its not lined up according to what the site...

Just replaced my cracked bellhousing and throw out bearing sleeve on the tranny and now the clutch pedal is limp after install. it was fine before install. Have to wait till monday to work on it again. Have to figure out what it might be. What do you guys think?

I have had my cobra for about 3 months now. When I first got the car the belt had a little squeek to it so I replaced it It was a gates belt that was on it when I got the car well I replaced it with a napa belt with the same part number. Well a month later had to replace another belt...

^^^^^ that made my night.

No longer for sale. Going to keep it .

http://i1128.photobucket.com/albums/m485/bighenry25/Jeep%20srt8/IMG_1800.jpg http://i1128.photobucket.com/albums/m485/bighenry25/Jeep%20srt8/IMG_1800.jpg

Jlt cold air intake. Amazon heat exchanger. Exhaust: 3 inch flowmaster catback. Stock manifolds. Spec 3+. less than 1000k. 26 spline input shaft. fidanza aluminum fly wheel. Ready for blower upgrade. Stock rear end. stock 17x9 machined up front with nitto 555r (non radial)...

Never thought I would have warranty work done with the black blower option. After I got the KB on and tuned, I was told that my pump was being speratic(sp) Didnt think nothing of it for about three months, blasted on it until one night when I had a little spirited run and car act like it wanted...

On the old style 2.2's What is the purpose of the nozzle on the top right of the blower, I have it capped off as of now. Do you guys have any pics of what it exactly supposed to be hooked up to? Im not leaking any oil out of the old style im just trying to figure out what it supposed to be...

A guy that I know that goes to the same gym as me has an ls1 trans am. He tells me his mods are 250? shot, automatic with converter, 3.73's, longtubes, I mean this thing sits about and inch off the ground. Says he has a diablo tuner, and a COMPLETELY STOCK MOTOR. Says he runs high tens. He...

http://www.badmustangsclub.com/gallery/misc.php?do=downloadfile&i=11737 This was about a month ago. I am so freaking happy with it. Poor 315 nittos. Do you guys think that the flows are not deep and loud? Kinda responding to the Flowmaster thread earlier.

I bought the XPD from lethal, plus the wiring upgrade kit. How hard is it to put this thing on? Planned on installing the kb this weekend, just wondered how hard it might be. Thanks, Hank