Foghorn's latest activity

I dropped this on the Fox body forum b/c technically it is one…just with two more doors. I’m building a ‘84 LTD LX. I have several...

Shit man wish I’d thought of that. I cobbled together a hydraulic setup on my 73’ CJ5 and there was just slight constant pressure at...

deleted post for brevity.

deleted post for brevity.

Update: It’s important to make sure that there is no preload on the master cylinder during the bleeding process. Preload will close...

I actually still need to put mine in. Here they are

Some pics. Were the tabs are. None broke either cause I was carful. 2004 Cobra 2.9 Whipple

So it was easier than expected. Popped it off with long flat blade screw driver getting under 3 tabs Added 3m thin automotive double...

Is the feed from the master cylinder connected to the bottom of the bearing? I have had to bleed two of these and the first one was...

I have the MDL conversion kit. On the Cobra, the driver side cam cover has the PCV valve located on the upper rear corner. It is very...

Threw in the towel and pulled the trans back out. After three times in two weeks, I can do it in just over an hour . I found that I...

Thanks for all the suggestions. At some point I have get past the “if at first you don’t succeed, try, try again” & move to Einstein’s...

yes, the MC hose is on the bottom and the bleed hose is on the top. I have vaccumed the bleed hose, but not the MC feed hose. FWIW...

TOB moves as soon as the pedal is pressed. I can’t get it to move enough to release the clutch. I have no indication of air in the...

Yes. Tech support is available and have been as helpful as can be over the phone.