Recent content by Fiveohdean

WTB – 03/04 Cobra eaton with low miles, stock or ported. Prefer SoCal area so I can inspect/pick up but will consider others.

My order for Nitto 315/35/17 DR's was cancelled last week. Any idea when they will be available again?

Can you spot the best of show winner?

Rumor has it Tetge had a bad day today and is buying a Lightning tonight. Anybody else heard anything?

Since my original trans didn't have any of the common TOB/clutch/retainer/clunk problems that many have had I put off taking it to the dealer for as long as possible. Unfortunatly I had a bad 6th gear syncro from day one. Started out just occasionally popping out of 6th gear while shifting...

Just mounted a pair of 26 x 11.5 ET Streets on 16 x 10 with 6" back spacing Diamond Racing Wheels. They may not be the best looking wheel in the world but for $125 each they will be just fine for driving to the track and back. There an easy fit with 5/8" clearance between the stock IRS bolt and...

Where is the relay switch for the fan? I need to know which wire to use to turn the fan on. Anybody know which pin # it is or where it's located?

Still no 11's for me. Made 5 passes at LACR today. Spun 3 times resulting in 12.2's. Two best passes were: 1.912/12.011/117.46 1.923/12.069/117.58 For what it worth corrected for LACR's 2710' elevation thats an 11.65 @ 121.5. Still havn't learned how to get the killer 60' times with...

I'm installing JBA shorties in my car. Passenger side went fine. Drivers side is in but the steering shaft is tight against the headers. Anybody else have this problem? How did you solve it?

Just got back from dyno testing Accufab's throttle body & inlet. Previous best pull with the stock TB was 494 RWHP/536 RWTQ STD. No changes other than the addition on the new TB was made. I put about 300 miles on the car since installing the new TB to make sure the computer had time to adjust...

Just completed installing Accufabs TB & intake. Installation was a snap. However, access to the lower rear intake bolt is limited due to the fuel lines. Before I began the TPS voltage was 1.06 with the stock TB. I also attempted to run the car with the IAC disconnected to see what the stock idle...

Came home after a few days out of town and found my Accufab Tb & inlet had arrived! That's the good news. The bad news is I found it in the middle of the lawn with no packaging, gaskets, instructions, etc to be found. FedEx threw the package over the fence when I was gone and my dogs shredded it...

Just got back from LACR. Got in quite a few passes. All were quicker than my previous best. Traction was limited as usual. Never made a pass without either spinning in first or second gear. One pass I spun in 1st, 2nd, and 3rd gear. Best 60' time was only 1.950. Times were as follows: 12.57 @...

Any one installed a Mac O/R H-Pipe on their 03 yet? I tried Mac's Pro Chamber H-Pipe on the Cobra but it hit the trans mount. Installed it on my wife's Bullitt instead. She's happy but the Cobra is still painfully too quiet.