Hawk HPS HB111F.610 Front Brake Pad set and Hawk HB183F.585 rear brake pad set. New in the box (the boxes are beat up but the pads are 100% brand new and in perfect condition).
Fronts Fit:
FORD MUSTANG BULLITT 4.6 2001-2001
FORD MUSTANG COBRA 5.0 1994-1994
FORD MUSTANG COBRA 4.6 1996-1999...
2003 Sonic Blue - 2.6KB Cobra -48k miles - $22K
Tough decision here but putting my 03 Sonic Blue KB Cobra up for sale. Put 3k miles on it in 2 summers and just cant justify keeping it with such limited use. The car doesn’t see rain or bad weather. She is garaged and covered all year. No...
Can someone tell me what this is? It's labeled PPRV delete but looks like it would fit where the FRPS is on the fuel rail, so i'm assuming they mean FRPS delete?
PPRV Block Off Plate - SN95 Fuel Rails
Am i way off base?
I keep blowing FRPS on my 03 Cobra with Fore rails (built in KB...
At the end of last season i managed to spike my fuel pressure and, i assume, crack the FRPS because i'm throwing the high/low fuel rail pressure code.
The last few days in the garage, the car would leave a strong fuel smell and take a little bit of cranking to start, resulting a little bit of...
When i park my car i smell gas immediately and hear what i'm assuming is a gas leak. I just hear the sound when the liquid hits, i'm guessing the exhaust in the back of the motor. I have been in the engine compartment and cant see a leak anywhere, so i'm assuming its on the backside of the...
Need a new radiator fan, mine died in typical Cobra fashion.
Has anyone had good luck with the Dorman replacement brand or should i stick with OEM. At less than half the cost of OEM, i could order 2 of these and still have some cash left over.
Dave
My car is throwing a code for either high or low fuel pressure in the rail. I've read that this could be due to a cracked fuel rail pressure sensor and see that Kenne Bell has a fix for it. Is there any way to examine the sensor for damage before just buying a new one?
I have a KB 2.6...
My throwout bearing is chirping away so it needs to be replaced. My Spec Stage 3+ clutch has almost 20K on it so i think i'm going to swap it out as long as the tranny is dropped.
I believe the Spec3+ kit comes with a Throwout bearing, am i better off buying a Ford Heavy duty to bearing...