Recent content by dvswim

1999 Ford Mustang GT SOLD SOLD SOLD SOLD Chassis has 85k miles Motor has about 10k miles on it. Just switched to Castrol Synthetic. Car is Electric Green Pearl. Tan leather, Mach 460 Sound, CD, AC, Heat. Full Street car. Passes emissions. New battery, alternator, steering rack. Asking...

Looking to trade for a set of drag rims and tires (Bigs n Littles). Prefer Weld Draglites or Prostars. Radial back tires a plus too. My setup consists or 4 chrome cobra R rims in very good condition. Front tires are 255 wide KdW-2 with about 40% life left. Rear tires are 275 wide Sumitomo...

Looking to trade for a set of drag rims and tires (Bigs n Littles). Prefer Weld Draglites or Prostars. Radial back tires a plus too. My setup consists or 4 chrome cobra R rims in very good condition. Front tires are 255 wide KdW-2 with about 40% life left. Rear tires are 275 wide Sumitomo...

Just like title says. I am wondering if i need to balance my et streets. They use tubes inside of them.

I was swaping out my stock manifold for a profesional products one and when i removed the stocker it gushed coolant into my open ports in the head. Ive got puddles of coolant just sitting there. I tried to use rolled up paper towels to dry up some of it but its very hard to get to it. Do you...

I've got some damage to my roof from my hood flying up. I need to remove the roof padding so i can get to some of the dents to pop them out temporarily. Does anyone know exactly what to expect in removing the headliner? Is it held on with just clips or are there hidden screws anywhere that i...

Im trying to figure out the correct adjustment on my car. Im using the granetteli billet clutch quadrant and the maximum motorsports firewall adjuster. My pedal height is pretty tall (about 2 or 3 inches higher than brake pedal). When i push the clutch in i hear a whirring sound from the tranny...

I just installed a remanufactured alt. and brand new battery in my car and noticed that the alternator bolt that the wire bolts onto was glowing while the car was running. What do you guys think this might be? Bad alt. or the wire itself went bad?:fm:

I need the whole fuel pump assembly including the socks, fuel lines, brackets and lid to the tank. I bought fuel pumps thinking it was a drop in, but they turned out to be just the bare pumps. This is going into a 99 GT btw.

IS there anyhting happening at the CT area some time soon. Any crusies or meets or anything. Been hanging out with the old import crowd since i got my stang and want to meet up with some fellow mustangers/cobraers (SP). lol:banana:

I just got my chip taken out and my ecu flashed with an sct xcal 2 by my tuner Jannetty racing. Every once in a while my batt light will flash on or fade in and out. The thing that worries me is that sometimes it comes on bright and my gauges seem to dim down. After some time it will go back to...

I just got a forged motor into my 99 GT and was wondering what size pulley to go with in order to get around 500/550 whp? This is on a p1-sc blower. I plan on getting methanol inj. and then eventually doing full headwork (cams, port, tb, plennum, etc).

Whats the largest mill possible to sqeeze into a sn95 chassis without having to chop or cut sheetmetal?

I just recently swapped the old blown 4.6 sohc shortblock on my 99 gt for a new MMR forged shortblock. Connected all the wiring harnesses correctly (As far as i know). I hooked up the return spring on the throttle body but somehow founda second identical spring laying around later on. I dont...

I installed my new cobra block and the little plastic clip that sits on the oil filter sandwich plate broke off becasue of a protrusion on the block. Does anyone know where to order this part or some sort of an extension so it fits correctly?