Recent content by dtonesfan

My 99 cobra needs a transmission to handle some power. now what would be a better choice the TKO 600 or a T56 viper spec im looking at getting a solid trans to handle 600ft pounds of torque with ease. i want to put in one trans and have some soild long term reliability. If i go with the t-56...

Hey guys need some advice. I got a 99 cobra with a fully built motor and want to add some boost. I saw on the kenne bell web site the 2.1 with the intercooler setup and cant decide between that and a F1-A procharger. I love the way the F1 sounds but cant find a kit for it all i can find is...

ok my car has a oil leak and it might be the oil cooler. i look un der my car and where the oil filter screws in. there is a bolt on the bottom with a hex head on it. its unscrewed out about two threads and i can see a orange ring. now is that suppose to be fully tighten so you dont see any...

ok my abs module dont work hense the abs light is on but i dont plan on replaceing the module cause i dont drive it in the rain or snaow and there expensive. is there a way to get rid of the ABS light in the dash its annoying to stare at.

Hey guys enjoying your weekend. I need some advise, i got a 99 cobra stock IRS besides gears and want to know if i should just beef up the IRS with some DSS half shafts, 03 diff, IRS brace and replace all the bushings cause mine are all bad. Or should i swap for a solid axle because i dont road...

Ok im looking at replacing my MAC LT's with some SLP LT's but on there web site they only say there compatible with 03/04 cobra and Mach 1. Also they have 1 3/4" PRIMARYS and all i can find for 99/01 are 1 5/8". will the SLP's Work? And will they bolt up to a Prochamber with no problems. I want...

Hey Guys on my 99 cobra i got some Eibach Lowering springs but other wise the front suspension is stock. I got a killer deal on some MOOG OEM lower ball joints cause both of mine are bad. My question is will these work fine or do i have to get the Steeda X2's.

Hi, my IRS in my 99 cobra is stock besides 4:10 gears other then a IRS brace what else is best to replace to stiffen it up. I dont have the cash to replace the halfshafts now. I would love to take it to the track and not snap one. I wont be dumpin the cluch just easin out of first with street...

Hi im new to SVTP and got a question regarding my oil pan in my 99 cobra. I believe its leaking at the gasket and want to replace it with a Canton 7 quart pan with the windage tray. Well i got long tubes on it and was wondering if i have to take off the headers to replace the pan. Also i think...