DCguy's latest activity

It should work if you do a v-band right after the muffler and then another one on the other side of the axle. You need 2 per side in...

Bassani is like the only 3in i know of....think also Magnaflow made one? I'd take it to a good exhaust shop and have them custom one...

If youre pulling the whole thing apart anyway id def have the heads gone through and freshened….valve job, new seals, guides...

I dont understand what folks find appealing about these….its really cheesy IMO. If anything the text should be where 4th gear is, not...

Keith Rhea of Wonder Racing in PA is one of the best 4v engine builders in the country. And Wicked Motorsports is right around the...

No clutches..its a helical setup like the Trutrac, but with high quality billet housing and ARP hardware etc. Similar to the Wavetrac.

This is quite impressive. Do you have a document perhaps you can share with bolt part numbers for each area?

I have the same setup as you (Strac 35 spline, strange axles, C-elims, factory ends). Not sure if this might be your issue, but when...

I can understand people's frustration but I think this statement is a bit unfar. They are standing behind their product are they not...

Personally i'd pull the heads while you're in there and have them freshened. Get new exhaust valve seats as they are an issue, new...

MHS, MPR, VMP etc are all in FL and specialize in mod motors

When wheels are widened they will typically cut the barrel toward the inner edge since the bore and spokes of the wheel are more toward...

MHS did mine. Jordan does fantastic work. Livernois is almost double the price in their quote to me. Janderson heads out of MN, TKM...

If money was no object......a restomod high end restoration would be in order. Think Singer built classic Porsche, but for a Terminator...

Go for it.....sounds like a solid car.