DCguy's latest activity

  • D
    I have not had a chance to drive with them yet but I did install them. I have spherical eyelets on the lower shock mounts as well so i...
  • D
    DCguy replied to the thread Ported VMP 2.3 Dyno numbers.
    Whats the timing at? What were the ambient temps and IAT2 temps? What is elevation? SAE corrected or standard numbers? Mustang dyno or...
  • D
    That's unreal dude.....unemployed or not, guy should figure it out. Pay you back over time or something. Or when he gets a job. These...
  • D
    DCguy replied to the thread 03 Cobra: Teksid Build Questions.
    For a built motor i would skip OEM head bolts and go straight to ARP studs. Get the 2000's if you can swing it. Buy once cry once.
  • D
    DCguy replied to the thread 03 Cobra: Teksid Build Questions.
    This should give you the full scope on Teksid conversions from Malcolm's website...
  • D
    Like Bob said above, don't sink any money into it until you know what you're dealing with. First thing to do on the list is check...
  • D
    DCguy replied to the thread Sigala carbon fiber pieces.
    Im glad you've had good luck with your pieces and, like said above, give credit to them for producing carbon parts for these old cars...
  • D
    DCguy replied to the thread Coilovers .
    Whatever you choose make sure your shocks/struts are valved to the spring rate you're using and also that you can select what spring...
  • D
    DCguy replied to the thread Belt size ?.
    Guys, string your cars. Aint hard.
  • D
    If you already know generally how to set up a tune, your idle, fuel tables, spark etc you'll be fine. But if you're talking about...
  • D
    DCguy replied to the thread 2003 Cobra - Dyno Results.
    Anytime dyno numbers are posted we need to know mustang dyno vs dynojet. Standard numbers or SAE corrected? Without knowing those two...
  • D
    DCguy replied to the thread CCW offset help for solid axle car.
    Well that's one reason Ford put them on there sure....its still an additional damper on the axle which on an SRA with coilovers is going...
  • D
    DCguy replied to the thread CCW offset help for solid axle car.
    Im building the car to be able to take a corner and do the occasional HPDE event......not so much drag oriented other than digs on...
  • D
    DCguy replied to the thread CCW offset help for solid axle car.
    I measured the rear end housing when I rebuilt it to make sure....its a 99-04. It has the 14mm lower control arm bolts as well. I don't...
  • D
    DCguy replied to the thread CCW offset help for solid axle car.
    The offset is more for determining the outside fitment ie the wheel lip with the fender. For clearance to your interior component ie...
    • IMG_0070.PNG
    • IMG_0065.PNG
    • IMG_1169.PNG
    • IMG_1170.PNG

Top