dazwelding's latest activity

  • dazwelding
    dazwelding replied to the thread Belt issues.
    Just ran at Roebling Road Raceway yesterday, and had no belt issues!! Spacing the lower pulley out fixed my issue! Just to close the...
  • dazwelding
    dazwelding replied to the thread Belt issues.
    I spaced out my lower pulley and it seems like it may be fixed. I guess I will know for sure after the next track day. Thank you all...
  • dazwelding
    dazwelding replied to the thread Belt issues.
    I will have to check the calibration. It was very challenging getting the tools on the pulleys in the same grooves for sure. What did...
  • dazwelding
    dazwelding replied to the thread Belt issues.
    Since I cannot figure out how to post the video, here are screenshots at RPM at the moment the belt pops over the top of the front of...
    • 81BFEB67-F52F-47A0-9DF2-228C64D80293.jpeg
    • 8881F91A-3047-4A93-B987-F7FBFE15DFDD.jpeg
  • dazwelding
    dazwelding replied to the thread Belt issues.
    Yes, tearing off the front rib, ie on the radiator side.
  • dazwelding
    dazwelding replied to the thread Belt issues.
    Everything is new, or at the most on the car for only a year. I have 1mm spacers for the alternator pulley, but that would push the...
  • dazwelding
    dazwelding replied to the thread Belt issues.
    I am back trying to figure out my belt issue. I made some short videos, but I cannot get them to post, so I will do my best to explain...
  • dazwelding
    dazwelding replied to the thread Belt issues.
    Ok, so no damage on any of the pulleys. I checked again with the laser and they are all aligned. My current next attempt is to either...
  • dazwelding
    dazwelding replied to the thread Belt issues.
    I will definitely look for this next. I haven’t noticed any damage, but I have not specifically looked for it either.
  • dazwelding
    dazwelding replied to the thread Belt issues.
    Wow, no powder coating for me. Good to know though
  • dazwelding
    dazwelding replied to the thread Belt issues.
    Interesting, I have a PA performance alternator I installed as it came from them- ie I did not install any spacers. Maybe I need to...
  • dazwelding
    dazwelding replied to the thread Belt issues.
    Yes, Pro Dyno and I both used the Dayco Laser kit. Radiator side every time.
  • dazwelding
    dazwelding posted the thread Belt issues in Engine/Tuning.
    I am continuing to tear up supercharger belts- IE: shred one rib off of the belt, and I am looking for input on what the cause may be...
  • dazwelding
  • dazwelding
    I see everyone is recommending to fire it up, but I primed mine before starting when it sat for a couple years. Good to know it should...

Top