D2M

Hey,

I am going to put my Roush Splitter on, and I found the thread with your reinforced install, and I just kinda wanted to pick your brain a tad on the fab of the aluminum bar... how exactly did you get it to bend into the shape into the bumper. I was thinking about cutting my piece of aluminum and doing 2 separate pieces with 3 screws being in each one instead of the whole piece across the front accounting for all 6 screws. Also was there a certain size rivet you used to hold the aluminum on?

Thank you for your time

Hi D2M. Your car looks great. Being a track guy as well, I ordered the same wheels as you for my 2011 GT Brembo. I know strut and caliper clearance are an issue, and I know roughly by how much. Any input you can provide re: spacer would be greatly appreciated, the wheels are going on one way or another . I know I'm asking for classified info so here is my email: [email protected], I promise not to share. I don't use the forums, just signed up to ask you this question.

Thanks,

John

Offset is top secret for now.. I have full GC coilover set and all hotchkis arms..

I was checking out the wheel and tire thread and came across your ride. Love the setup, Looks sick! I was Also wondering what offset you where running along with what you where lowered on.



Thanks

I was checking out the wheel and tire thread and came across your ride. Love the setup, Looks sick! I was Also wondering what offset you where running along with what you where lowered on.



Thanks

what offset are 19x10.5s ? nice setup btw