Recent content by CobraT_Type

I'm going to be getting a TKO600 transmission, and it says I have to lengthen my driveshaft. I am supposed to extend it by .625". How do I do that? And it also says I'm supposed to modify my crossmember, how do I modify it?

So I'm getting my engine put back together, still have a few things to finish with it. Now comes the big question.... how should i time it, or who should i have time it? I have a 347 stroker kit in it, with forged pistons and I beam rods, magnum roller rockers, a double timing chain, gt40p...

So I'm putting my engine back together after having it machined and bored out (my 302 block) and I have about a quarter inch to a half inch gap between my intake and my block. I'm running the gt40p heads. Does anyone know of a spacer that will work for this or is there something else I can do...

So I'm having my block bored .030 over and I wanna run a procharger, what's the best piston to use in this case as far as compression?? I have the 5.0 btw.

I am getting ready to finish my build in the next few months and habe no idea who to take my car to, to get it tuned. I live in IN so anyone who knows of a good reputable person/company I would appreciate it. Thank you ahead of time.

I was just wondering what size push Rods I will need for my build. I have a set of gt40p heads with Alex springs, comp cam magnum roller rockers, comp cam lifters, and a 270h cam. Any kind of help would be awesome thx guys/gals!!

I'm getting a set of gt40p heads and I'm gonna ha e them port polished and machined. Does anything need to be milled down to fit with a heavier cam? K352463 is the can kit I got and 143116 for rocker kit from cjpony. Any help would be great!

So I tried to install a cd player a Lil back and it worked good. Except I wasn't getting any sound from my front speakers cuz I don't think I had the right wiring harness for the amp interface. Can anyone point me in the right direction? I tried to search the forum but couldn't find a part...

So I'm kind of stumped on what I wanna do for my next set of Mods. I wanna go all out with this thing. I have a 95 Cobra vert, and so far I currently I have done the following; taken the mufflers off my exhaust, (there were holes in em and it was the cheapest route at the time), 30# injectors...

Ok so I just installed 35# injectors on an internally stock 95 cobra, because I was having idle issues. The car was idling very rough even after the normal checking on the engine. Now it idles better but it's idling very high even with my 75mm throttle body turned down and it chokes out when I...

So i have a 95 cobra with mild mods. So i jus replaced my distibutor cap and rotor and now my car is stayjng high in RPMs when i hit the clutch to shift. Any ideas why?

So about a month ago i had a tremec tranny put in my 95 5.0 cobra. Now it is making a whining noise, that sounds kind of like a supercharger , in 2nd & 3rd gear. Im stumped. Any info would help greatly. Thanks!

Just wonderin what the best plugs are for the SN95.

I have for sale a never used turbo setup. Comes with all piping and intercooler. The intercooler was put on a vehicle and ran for a month then taken off. I would prefer a pick up in South Bend IN. Cuz shiping would be very expensive for the buyer. Thx for lookin. Pm me for n e more questions...