Recent content by Clubcart84

greased every slide and pin really good and reassembled. will test ride and keep an eye on that brake hose. all old grease was about gone and hard, hope thats all it was.

Just pulled the brake apart and everything loose like nothing ever happened

rear driver side brake hangs up after new pads and rotor where installed. Put a new caliper on and still hangs up. The porportion valve would have nothing to do with this?

Wondering if anyone has a set of converters for a 2000 lightning for sale

2000 lightning question need help with. behind the under hood fuse panel there are 2 small harnesses coming out of the main harness. 1 of the harnesses is a green orange strip and a black wire. Can anyone tell me where that harness plugs in?

New thermostat, radiator, water pump and hoses. It suck shut whether cold or hot.

vacuum the system down and then filled. Also burped it many times after filled. Did all this after replacing blown head gaskets. I know the head gasket job worked well because temps would run over 230 and now at idle 210 max. It also held vacuum for 15 minutes when I filled the coolant system...

I am running a new 3 row spectra radiator and just ordered a spectra condenser which is more open to allow air to flow. The same p/n is used for 96,97 and 98. Hope this will make a difference. Down low the condenser is completely clogged up with crap and fins are all collapsed

Is there any one better condensers then others

Think I figured it out. After crawling under the car the ac condenser is discusting

what did the service bulletin recommend replacing? could not find it online.

Not sure what tsb is

at cruising speed temps reach 210-215. Fan is running and pulling good air. New radiator and water pump. Antifreeze was filled by vacuum and burped as well. Is the temps normal?

I do have a lift. Will look at when I get home

No other hoses to it. must feed through the block