Chrisg2121's latest activity

Final update for the 5.4 3v roush

Minor update on the 5.4 3v Roush Got a front bumper directly from roush took 8-9 months to be made/delivered, fresh laser red paint...

Yea with a lift it’s very easy Remove driveshaft, shifter assembly/clutch cable or auto shifter cable off trans Drain engine, trans...

Soon.

Got the correct size injectors on it, got the throttle body on it, installed new shocks n struts, bled the brakes, hooked up the amp...

Got the suspension assembled, sealed up the diff, n replaced the drive shaft u joints. Also got a Honda power steering reservoir with...

The 2v elbow shouldn’t be much of a restriction the mustang throttle body is 70mm I believe the 5.4 3v throttle body is 75mm. I’ve...

Got the exhaust all done today I got it tucked up tight so hopefully it won’t get dinged up anymore I got the lightning style tips on I...

Some before n after pics of the engine n exhaust. Still need to finish up the rest of the exhaust Also got an x brace off an sn95...

I took this video today after getting the vacuum leak fixed, rear o2s, n x pipe installed. Still have not finished both tailpipes Once I...

Found my vacuum leak i accidentally drilled too far on the passenger side when I was drilling out a hole to install a freeze plug to...

Got the cats on with the front o2s installed also got the radiator on there n filled it with water, filled the engine with oil n it...

Got it together for the most part. Ended up using the 1/2” k member spacers. I was able to reuse the mustang heater hoses with some...

Got the wiring done. Also swapped the iac for a crown Vic one it holds the connector out straight facing the throttle body instead of...