I can only speak on my experience with decipha as I've never used Lasota. He is by far the best tuner that I've had tuning the cobra. He knows these ecu's inside and out and a stand up guy. Heck he even hit me up a few times when he was passing through my area to see if I needing any tweaking...
I recommend posting this on efidynotuning and asking decipha. Few people know the ins and outs of our ecu's better than him. He does post on SVTP on occasion but you'd probably get a quicker response posting on his site.
So how do u like the supersingle he? How is the fit? I have the VMP I/C on order right now, currently on backorder so don't when I'll get it, and I was comparing vmp gt500 he with the DOB supersingle. I've read all the gt500 HE install threads and how tight of a fit it is which gives me concerns...
Since this is android based has anyone tried an android head unit such as the Atoto A6 or new S8. I have the A6 which I really like and it will connect to OBD via Bluetooth through the torque app. I was wondering if the same could be said using shadow dash and the MSPNP
I'm selling my complete MM front c/o kit (part #COP-24). This kit includes the complete coilover kit with 350# springs and the MM New Generation (SP-1) sport struts. Asking $750 shipped you cover the paypal fee. The kit was installed in the spring of 2019 but has less than1500 miles put on it...
These nib never used maximum motorsports sport series rear shocks Part # MB-2959-S1.They are grooved to accept the mmcoilover kit or can be used as is with the purchase of the MM lower eyelet kit. I'm asking $350 shipped for this set.
I also have the full MM front coilover kit with the black MM...
Something similar happened to me. Car ran fine under normal load but would stumble bad under hard acceleration or wot and 100% duty cycle. One of the gt pumps had failed. Finding the bad pump was a little challenging I should have just replaced both of them which is what I would suggest. I run...
Its funny that u mention about the pivot ball length. I used the mcloed pivot ball and initially set it up according to information I got here which was about 6mm shorter than stock. This left the shift fork touching the trans and pushing against the clutch fingers. After multiple tries I...
I have a Benpak HD9 and the manual says bolting it down is optional unless you are using a bridge jack then it must be bolted down. I also have their standard (they also make a low profile) bridgejack but the subframe connectors don't quit clear it