Recent content by Braker85

SOLD SOLD SOLD Sent from my SM-N920V using Tapatalk

Sadly it's time to move on to something new. I bought the truck a little 3 years ago from another member. I'll get chassis has 169,xxx and the motor has been replaced in 2011. I cannot verify the milage on the motor. Right now it runs but does not drive. There is an issue with the transmission...

Used Roush TVS bare case. Case is in good shape from what I can see. This is a bare case only. No bearings, elbow, bypass, snout, mid plate or rotors. Asking $400 plus the ride.

Roush TVS bare case. Used but looks to be fine. This is a case only. No internals, no snout, no bypass just the case. $400 shipped in the lower 48

2002 DSG HD #7706 167,135mi on chassis roughly 15k on motor. Ford spec rebuild in 2011. Blower was rebuilt last month. Lightning upper pulley and snout. MP idler bridge with two 100mm idlers and one 90mm idler. C&L cold air intake and MAF with K&N filter. Accufab single blade throttle...

I know this is t "GT500" stuff but its close. Just finished this 112MP for a customer. Ported by Brett Lemenager and polished by myself (3rd Row Innovations). Also polished the plenum but that's going on my truck.

I know this is t "Gt500" stuff but its close. Just finished this 112MP for a customer. Ported by Brett Lemenager and polished by myself (3rd Row Innovations). Also polished the plenum but that's going on my truck.

Just finished this 112MP for a customer. Ported by Brett Lemenager and polished by myself (3rd Row Innovations). Also polished the plenum but that's going on my truck.

Just finished this 112MP for a customer. Ported by Brett Lemenager and polished by myself (3rd Row Innovations). Also polished the plenum but that's going on my truck.

I know this is t "Cobra" stuff but its close. Just finished this 112MP for a customer. Ported by Brett Lemenager and polished by myself (3rd Row Innovations). Also polished the plenum but that's going on my truck.

Need a polished tvs asap 214 771 1974

Does anyone in the DFW area have a puller to remove the pulley from the snout? I need one asap. Any help will be appreciated. Thanks

Have a dual over head console pod. Replaces the factory compass and retains all of the map lighting and sunroof controls. $225 shipped

Got a few shop tools I don't use anymore.......all are OBO located in DFW Acra 12spd Drill Press.....$650 obo IT HAS BEEN IN STORAGE AND WAS NEVER USED. IT HAS SOME SCUFFS AND DINGS FROM MOVING. ALSO HAS SURFACE RUST ON THE WORKING PLATE AND THE COLUMN. EVERYTHING MOVES FREELY. Utility...

A couple of gauge pods I have on the bench. I can add pedal or slider buttons. $150 each lmk