2013 F150 4x4
5.0 Ford Racing Aluminator
Custom stainless turbo kit by Gearhead Fabrications in Stuart FL
Tuned by MPT in Longwood FL
Twin precision 6266s
Circle D built the trans and Converter
Custom fuel system
93 octane pump gas 17psi 896/695
Roush supercharger phase 2 55,000 miles.
rod came through the block of factory motor, we have replaced the motor and are now going twin turbo...comes with the original motor, pulleys, brackets ,heat exchanger ,throttle body long tube headers Y pipe and v band roush exhaust.
$3500 located...
Forgive me I posted this in the wrong section, I wasn't sure where to post it.
A small introduction about me, I own a custom fabrication shop in Stuart FL. I specialize in fabrication and I do full race car builds/ street car builds or basically whatever my customers want.
I'm currently...
Selling this motor for a friend of mine he has lost interest in building his 97 Cobra so the shortblock has to go, here are the specs
-97 Teksid Block Standard Bore
-Balanced and Line Bored
-OEM Cobra Forged Crank
-Manley Forged H Beam Rods ARP Hardware
-18cc Manley Forged Dish Pistons...
Posting for a friend,a 1990 Mustang LX Coupe with a 306, TW alu. heads edelbrock upper n lower intake,ford E cam,intake,headers w/ pre axle dumps,MSD ignition,6 switch painless rocker panel,full drag susp. from UPR, spooled 8.8 rear w/moser 32 spline axles drag light rims, 6 point cage, NX Wet Kit
Long story short, my motor is going to have to come out and gone through, I'm thinking bearing failure, so I'm going to need some extra cash looks like the Kenne Bell will have to go.
Only 1800 miles since the rebuild from Kenne Bell (documentation available) has never been pulled over 14lbs...
Long story short, my motor is going to have to come out and gone through, I'm thinking bearing failure, so I'm going to need some extra cash looks like the Kenne Bell will have to go.
Only 1800 miles since the rebuild from Kenne Bell (documentation available) has never been pulled over 14lbs...
2002 DODGE DURANGO 4x2 SLT
I would say the exterior of the truck is a 7.5 out of 10, no major dents or scratches, couple small scratches and very few dings, the interior is about the same, theres one small rip on the drivers seat and a rip on the driver side rear seat belt, ac works great...