hey everyone,
i've been having some issues with my car ever since i installed the tvs,, first it was the belt slip and i removed the 79mm pulley and replaced it with a griptech 81mm pulley (problem solved).
second issue i had is that my boost gauge ( i'm using snow performance boost gauge was...
A Good choice in upgrading the intake manifold!
a very straight forward and easy, tune wise you should be able to drive it normally without any issues until you get it tuned.
you will require some changes in the VCT settings for the best angles for the most power and some really small...
Hey Red
Hey Reddick,
28'' in the rear (15x275x60).
i think my issue is with the launch and maybe the spark on the lower load, i feel like i should bump that up a little.
Time to Revive an old Thread..
so yesterday i finally managed to test my car after my new tvs setup, and yes the 60ft are still awful lol.
my best 60ft was 1.8 and the 1/4 mile was 11.4 ( i'm still running 14 degrees of spark ) and my trap speed was 124 mph.
i was launching around 1100 rpm...
i always love to share because i know one day someone will be in my spot and i might be the one who gives the solution :D.
no dyno yet, i'm taking it very slow i dunno why i'm not even excited for the dyno, maybe because i'm tuning it on my own, but will definitely share the numbers.
the...
well to update anyone who might have the issue.
problem is resolved, throttle is opening up perfectly. just had to do a ton of datalogs and work on the effective throttle area and it's all done.
car is very responsive and even at 50% to 70% pedal it pulls so hard. what is left is to complete...
that i will do perhaps.
so the update is my car won't accept the rewritten file i made yesterday, but my guess is that my effective throttle area is what causing the issues. so i worked that problem out and will give it a go.
UPDATE to REDDICK
the pulley is 79mm
i will check the pulley later on tonight. because when i first got the kit it had a much smaller pulley (69mm) and this is supposed to be the stock pulley (the previous owner was running 19PSI and i still have like 4 different pulleys not installed)
i did make the adjustments for the throttle...
the upper pulley is the stock pulley, my doubt is that my Boost gauge was reading wrong.
i just took the car for a long drive, the jerking is still there and my gas pedal feels so heavy especially between the 2k to 4k rpm. I'm not sure if it's my Throttle although i'm sure my values should be...
Hey Guys,
so finally, i installed my Roush TVS blower, ran into some small problems, like the tune file i was using was corrupted, and when i used a different strategy some paramaters were missing and SCT were super helpful to help me get it fixed.
so finally i started the car and it feels...
Hey Everyone,
so a while ago i purchased a DSS driveshaft The Driveshaft Shop | 2011-14 Mustang GT and BOSS 302 6-Speed Manual or Automatic 1-Piece 3.5" Aluminum Shaft with Direct Fit CV - 2011-2014 GT - GT - 2005-2014 - Mustang - Ford - Domestic Driveshafts
as per the description, it says...
Hey guys,
Few months ago I bought a roush tvs blower for my coyote and since I drove the car that the blower was installed on and literally abused it before removing it I had no concerns at all since the car was performed great with no issues.
Today while I was inspecting the kit I noticed a...