Friction modifier adds additional slipperiness to the oil which allows the clutches to slip without chattering. Friction modifier reduces the coupling ability of diff clutches so run the minimal amount necessary to eliminate the chatter in a turn and no more.
Additional friction modifier is not needed unless you get chatter in a turn; adding an extra bottle just to do it reduces the ability of the diff clutches to engage.
I've had Severe Gear with no extra friction modifier for over a year with zero diff chatter.
Try it without it first...
You aren’t arguing with someone who doesn’t understand, you fail to to understand.
Cody’s combo isn’t a “max effort build”.
Cody’s combo may near the limits of his parts, but that because it ISN’T a max effort build.
I built the engine, I spec’d the pistons/cams, I know what was left on the...
The timing was held back because we
honestly weren’t chasing a dyno number.
19 deg was nice and safe on the plug, so we called it a day. Going by the plug, it could have taken another 2-3* before the timing mark neared the bend but there was no point in pushing it, the combo already exceeded...
No, it isn’t. Again, take the last combo I laid out and drop the compression ratio. That is what a true max effort “Street/Strip” combo looks like.
You specifically asked me to tell you what max effort build looks like, I obliged. It doesn’t look like Cody’s build, which left quite a bit on...
VMP 173 on the top, KB 168 on the bottom. The 173 definitely leaned out Cody’s tune, so there was some air flow improvement with it. Still unsure of any direct gains because the 168 went into failsafe @ ~6000 rpm every pull.
A back to back comparison on a 1000+ rwhp combo would be interesting.
It’s not splitting hairs, there’s just a difference between a fairly basic,
matched rod/piston/H/C combo and a true max effort combo.
There will eventually be a ceiling imposed by the engine’s architecture.
The point I am making is that Cody’s combo is not a max effort combo even within the...
Nothing about the combo is max effort. The heads aren’t max effort, just Ron Robart’s standard GT port with stock valves - 350/300. Not his large port/+2mm 390/350 heads.
Stock cube, stock crank, iron block, 10:7:1.
The combo is pretty basic, just pretty well matched at this point.
What...
The VMP 173 is the largest/highest flowing DBW oval throttle body on the market that I'm aware of. It is a good bit larger than the KB 168.
The revised 173 version has been working well on Cody's car.