Recent content by ar_snl

The gasket i have for the throttle body does not have a cut out for the little air holes that tha throttle body has. Most likely my problem. im gonna cut it out or get a new gasket and see how it goes.

Dusten is correct on what is goin on regarding your explanation. You have heater circuit codes which point to 02 sensors but... I would first see where the extra air is getting in from first. It is after the Maf and before the 02 sensors. Check the intake manifold, intake, and exhaust manifold...

Thanks for that reply. I had noticed when i open the idle screw, it will turn on but after a couple seconds it will idle up to 2k rpm. If i have it adjusted, it will not turn over. Ill make sure to get that throttle body.

I have a question abou the theottle body. Does the throttle bosy have a hole on the middle bump? Because i am using a mach 1 throttle body I think and it doesn't have that hole and it might be a problem.

Check that the idle screw on your throttle body is 2 1/2 turns open. And lastly drain your gas and add fresh gasoline.

Ill note the issues i had that caused this. My TPS was faulty. It was causing the car to spit more fuel and back fire. My MAF was messed up. I unplugged it and it ran. Not great but i could keep it idling with some throttle. Check your IAC. There are two different brands of IAC valves. They...