If there is no signs of leaks at all externally, You probably have a leak in the brick under the blower and its being burnt in the combustion chamber. Very rare but possible in GT500 but actually very common in Audis.
I have been looking into it as well, Technically You can go into neutral in any gear, 1/2 push or 1/2 pull BUT when you come to a stop then you would need to bang down to first. Still a bitch but you can coast in.
I have a saleen watts link for years and had to go back to a two piece drive shaft. Some guys are lucky with the pinion angle if the car is not too low. But if you are sig lowered you cant adjust it enough with the watts. Binds.
Tried two different one piece drive shafts. Would vibrate between...
If you plan on going to the track a lot I would go Spec. If not rxt is a friendlier clutch for street use.
I have a spec it's very good but it's very on off within one inch of travel. Not heavy at all though.
Sent from my iPhone using Tapatalk
A lot of people would have different opinions.
The TVS is a great supercharger no doubt makes instant torque.
But the Kenny Bell will always make more power at the same boost level period.
If you're trying to make 750 at the wheels on pump 93 I don't think you'll be able to attain that with a...
I would just purchase stock lower ca and upset from someone here.
I'm sure you can get them for peanuts since that's ghe first thing most change.
Sent from my iPhone using Tapatalk
Keep in mind the 07-09 have ever so slightly smaller hips that a 2010 up. I don't think a 335 mich would fit on my car it's that close
Sent from my iPhone using Tapatalk
I don't remember exactly the offset but basically it's the same as stock but the back spacing is 2.5 inches more. All in the back the front didn't move at all.
Sent from my iPhone using Tapatalk
I don't for now. I would check on the nitto web site for widths your 315 may be close depending on manufacturer. I know Michelin's run bigger. The 335 and 345 dr are on 1/4 inch difference in width
Sent from my iPhone using Tapatalk
I run 11.5 inch wheels and 335/30/19 nitto
tires with bracket removed.
You can run 345 nitto DR as well.
I relocated the bump stops myself just used a square piece of metal and drilled 4 holes. Works perfect.
Nothing rubs while driving. Regardless of bumps.
It may rub a tad at very slow speeds...