Recent content by Annihil8or

For Sale: Diablo Predator tuning flash programmer and live data logger for Terminator, like new, with manual. $225 shipped.

SOLD California Car: My friend and employee is selling the '03 Cobra he bought from me. He's in a bad mortgage and must rearrange his priorities. The car has approx 44K miles and DSG paint. #5,269 of 8,394 DOB 2/7/03 Mods as follows: Fluidyne Heat Exchanger Magnaflow...

SOLD My friend and employee is selling the '03 Cobra he bought from me. He's in a bad mortgage and must rearrange his priorities. The car has approx 44K miles and DSG paint. Mods as follows: Fluidyne Heat Exchanger Magnaflow Catback, X-pipe, high flow cats and slash...

I need wheel alignment specs for open track use. The '03 coupe is set up with MM caster camber plates and coil overs. Thanks in advance.

I need some input for my buddy who bought my '03 Cobra. He spun out at Willow Springs and ruined the Fluidyne that I installed on the car when I owned it. :( He is considering a Gords as a replacement. Any feedback as to which is better as far as performance? Also, is the Gords a...

Does anyone know of a good alignment shop for open track (Willow Springs big track) and street set up? My buddy just had the motor replaced in his '03 and they had to remove the caster/camber plates and strut tower brace so I am sure the alignment got messed up. I have been trying to...

Due to engine replacement caused by spark plugs loosening and blowing out of cylinder head, the engine was pulled revealing a worn clutch and heat checked flywheel. Thread on this subject: here Stock flywheel: Since the stock flywheel is not serviceable, it is necessary to replace that...

My buddy's T3 developed what seemed like a misfire on one cylinder along with some odd noises. We took it to an independent mechanic today who found the problem. The number 3 spark plug on the passenger side of the engine had come loose and worked its way all the way out of the cylinder had...

My buddy who purchased my 03 Cobra is looking for a warranty for his car, anyone have any suggestions?

Can anyone please provide me with a source for a 160 degree stat for an 03 Cobra? I've tried Ford but no dice. Thanks

I have left and right Saleen sidescoops for '03 or '04 Cobra. They have been impeccably painted with DSG/Clearcoat Finish to perfectly match our cars. I paid $200 for the scoops and $200 to paint them and will sell for $300 obo. They are in perfect, new condition, never installed. Easily...

Well, it has been a fun 3 years. But the time has come to say goodbye to the T3 and say hello to the Z06. Since the Terminator is being sold tomorrow my new handle will have to be X-terminator ;-) . By the way, the Z06 is absolutely awesome... :pepper: It is a marriage of American...

I took my car into Star Ford in Glendale (the dealership where I purchased my T3) to have the throwout bearing replaced. With only 13,000 miles on the car this is definitely premature failure for the bearing but since it's a warranty item I wasn't alarmed too much. After they began work on the...

I learned my lesson, I will never buy anything from those thieves ever again. I bought a strut tower brace from them which turned out to be very shoddy. The welds were a joke, the construction and design looked feeble and it was far lighter than I expected. After I received the KB unit...

We just replaced our UPR Blue Thunder shifter (identical to Steeda Tri Ax) today with a Pro 5.0 which I ordered from StangShifters.com. The UPR shifter (for sale) is a very good shifter and much better than stock, however it is a bit notchy. The Pro 5.0 is slicker and quicker. Installation...