Recent content by - Aj -

Did any of you have to use a spacer for the panhard bar brace to drop it down a little bit, so it would make room for the over axle pipes?

@Robert M @Catmonkey thanks for the help fellas! Nice to still see you too are still here Robert M!

@Catmonkey good to see you are still here. I thought it was something along those lines. How much did you cut off? FYI to the other two replies, the exhaust tips stick out about 5 inches past the rear bumper since the header install. Does not change with temp.

Hey all! Been a few years since I have been on the forums. Still have my '08 GT500. One thing I never got around to was modifying the exhaust since the header install. The exhaust tips stick out farther than normal. From what I remember, I think the rear of the mid-pipe needs to be cut 1" to...

Pulley sold. Plenum still available! Increase your throttle response! Sent from my iPhone using Tapatalk

Have another offer at the moment Sent from my iPhone using Tapatalk

Yes it's for the Trinity. 2.396 from BPS to be exact. Sent from my iPhone using Tapatalk

Yes Sent from my iPhone using Tapatalk

Bump Sent from my iPhone using Tapatalk

Bought it used on here a few years ago Sent from my iPhone using Tapatalk

Both un damaged wheels sold. Thanks Paul! One curbed wheel left-make an offer! Sent from my iPhone using Tapatalk

Plenum dropped to $100 shipped-pulley now $80 shipped Sent from my iPhone using Tapatalk

>>>>>NOT A FULL SET<<<<< One (1) 19" wheel, no curb rash, with sct center cap - $250 + ship One (1) 19" wheel, some curb rash, with sct center cap - $150 + ship One (1) 20" wheel, no curb rash, with svt center cap - $300 + ship Only PayPal accepted. PM with questions. Sent from my...

Ported stock 07-09 plenum, nice work, not sure whose-$150 shipped BPS 2.396" pulley for 13/14 TVS - $100 shipped Only PayPal accepted. PM with questions. Sent from my iPhone using Tapatalk

Anyone have? Sent from my superfast Shelby GT500