Recent content by agof95

  1. A

    Smallest front tire on stock rim?

    I'm thinking about going with different sized tires front/back and need to know if a 245/255 is too narrow for the nine inch wide wheel.
  2. A

    Finally popped my cherry!!!

    First time at the strip for me and my car. The temp was around 50. I now know what wheel hop feels like. I accidentally drove through the water box on my first run ever and hopped badly (2.52 60') to a 13.20 @ 114. I managed to avoid the water box on my second run and it was my best of...
  3. A

    Passenger door alignment

    My passenger door isn't aligned properly. It appears that it should be raised up where it bolts on. The door rubs against the quarter panel and produced a squeak until I siliconed it. You can easily see that it's lower than where it should be based on the lines of the quarter panel. I...
  4. A

    Dallas area dyno shops

    My buddy (torch red '03) and I are planning on making a trek to Big D to have our cars dynoed sometime in the next few weeks and need opinions from the Dallas guys. I went by Speedworks in Lewisville last Saturday to check it out. It seemed alright, but I was wondering which y'all preferred...
  5. A

    WOW!!! - MGW shifter handle

    I installed the MGW handle on my car Sunday (right after the DC install). This is by far the best $35 I've ever spent on a car. The install took less than 30 minutes and what a difference it makes. You can actually feel the gates in the shifter. The transmission noise is quite a bit louder (I...
  6. A

    I'm finally a true member of the club

    I took delivery of my zinc yellow 03 cobra yesterday. I've been waiting for this since last summer. I took her up to 80 a couple of times to check for the vibe and felt nothing :) . She didn't vibe at 120 either :thumbsup: . This car is by far the best mustang I've ever owned. I traded in...
  7. A

    Wheel weights?

    Are wheel weights available that go on the inside of the wheel? If so, are they as effective as the normal ones for balancing? I want to avoid the wheels being screwed up due to different weight placements.
  8. A

    Side scoop removal?

    How hard is it to remove the side scoops? I assume the paint underneath would need a little work. The FR500 look is what I'm going for. It didn't have any scoops at all. Check out the link for a pic: http://www.stangnet.com/fr500/fr500rustya.jpg

Top