Alright, built a brand new engine, Whipple 3.4 on top, aftermarket dual BB idlers, stock caged lower, RR manual tensioner, RR 4" upper. I have tried both Gates green belts, and Gatorbacks.
I can't get consistent, not-dropping off boost to save my life.
Either it peaks to 18psi, and RAPIDLY...
Hate to start another belt length thread but tons of searching has not yielded me an answer for this combo.
3.4 Whipple on a 03-04 Cobra setup Teksid block, stock lower, have all the Divixion X idlers including snub idler, with a 4" blower pulley.
Thanks :)
For reference the previous...
I'm putting a 4V termi swap in my GT. The guy I bought the blower off kept the IAT/MAP sensor.
Now, of course I have no need for the MAP, is there a solution to put an IAT in the hole instead that will hook up easily? Or do I need to find one of those MAP/IAT sensors and just wire in the...
Need a set of rings for ONE PISTON from a set of CR8264-25. (or really just the top ring)
Or willing to buy all 8 if you have a box sitting around. I bent one of my top rings installing just now. Furious.
Thanks.
1 3/4" primaries to 3" collectors with a 3 bolt flange.
Driver's side collector has two bungs on it for OEM narrowband and wideband. Can include a plug if you only intend to use one bung.
*EGR pipe not included.
$700 + shipping.
Are the Comp 106400 cams suitable to be used with a 3.4 Whipple, 4.6 motor?
Should I be looking for something better suited?
Link to specs: 106400 - Xtreme XE-R Series