Recent content by AC Mech

  1. A

    AC not working

    2004 Cobra... after sitting for a year my air conditioner not blowing cold. The compressor short cycles which normally indicates low charge, however checking with gauge the charge is spot on. I jumpered the cycling switch so the compressor would constantly run. The result was the metal ac lines...
  2. A

    wtb Billetflow 2.76 pully ring in clear color.

    Title says it all...
  3. A

    lubricate before removing spark plugs?

    I want to inspect my plugs as they have been in for 5 plus yrs, and I am concerned about breaking a plug off in the head. Is it ok to use some penetrating oil to make the removal easier? Also the plugs have maybe 12k on them, do they need to be changed? The car runs great.
  4. A

    wtb BF 2.76 pulley

    clear in color...
  5. A

    Pulley puller needed Mobile, AL

    trying to help a friend.... for a 2004 Cobra.
  6. A

    Looking for a pic of Nitto 555r 315 on 10.5 rim

    A shot from the side and from the rear would be great.
  7. A

    anti-venom mod help

    So I get the required tools to reach up to take out the detent bolt, but damn I could not get it to come loose. For fear of breaking something, I stopped and thought it wise to consult the experts. Those who have done it how tight was it? Did it require a breaker or cheater bar? My tool setup...
  8. A

    do caster/camber plates affect ride?

    The reason I ask is a friend had some installed, and when I drove his car it seemed as if his ride quality had suffered. It does not make sense that they would affect the ride, but it seemed to on his. IDK maybe there were other factors at play I was unaware of. Opinions?
  9. A

    Slow to start

    After a recent visit to the track my car is slow to start. When I say slow to start it's not the starter not spinning it over quickly, it cranks for several seconds before lighting off. This is about two or three times as long as it was before. This only occurs after sitting several hours or...
  10. A

    Came up short...

    First time down the 1/4 since pullied/ported. I ran a 12.84 @ 110 with intake exhaust a few years ago. Yesterday at a track rental I gave it a go to see what she had..these are the results. 60= 1.95 330=5.3 1/8 -8.0 @96 1/4 = 12.1 @120 I wanted to try again for an 11 sec pass... 60=...
  11. A

    Drag tire selection

    I have the opportunity to get a great deal on two brands/sizes. First the BFG 275/40/17 DR, the other is M and H DR in size 275/50/17. I know the BFG has proved itself, and probably can't go wrong there, but I can't help but think that the M and H (28 in tire) extra sidewall may allow for a...
  12. A

    license plate frame suggestions

    I am looking for a high quality attractive license plate frame. I like the chrome/red SVT one, but not sure how it would look on Mystichrome. Any help appreciated.
  13. A

    94 Cobra shuts off

    Posting for a fellow Cobra owner. Sometimes while driving the car will just cut off, then start running again (off and on again quickly like you were flipping a switch). Today he was driving and it quit, and would not restart until it cooled off. Going of the advise off a local shop they...
  14. A

    spring fitament

    Will Mach 1(o3) springs fit my 94 Cobra?
  15. A

    Cobras after dark


Top