After talking to Power by the hour they said your can’t use factory computers because the computer looks for a lot of sensor that want be hooked up. Thanks for the advise guys.
I have been to their web sight I don’t see any kit or information on swapping the 10R80 in. I’ve seen a few with the 6R80. I was just thinking that if I already had all the ford control pack an the anti theft was disable everything should work like factory.
I’ve found a junk yard that you can buy the whole 2018 coyote engine an 10R80 trans from.They will disable the anti theft system so the car cranks an run so I don’t see a reason for the ford racing control pack. It comes with all the factor control packs so if this is the case could one just...
I have a R 331 short block boar .040 over for sale fresh out out the machine shop. It has a eagle 4340 forged crank, eagle 4340 H beam rods,probe low compression piston. The oil pan is also new just welded bungs in it for turbo return lines. If you need one I'll cut you a deal on it also. ARP...
I did a search and really couldn't find a answer.I have a 93 fox body mustang. I am build a turbo 337 set up. Can anyone tell me the advantages to a slot style MAF? I am looking at getting a new MAF for my car and want to make sure I get the best one I can.
I am looking for a mustang between 89-93 in NC in nice shape. I dont care if it has some mods done to it. I don't want a carb car or a salvage title car. If it has a carb on or is a salvage title car I want even look at it.
I am looking for a 2001 and up lighting. If I has some mods that is fine. I really don't want a red one and would like it to have less then a 100k on it.
Car has 156,000, 2 piston front calibers,saleen springs,alum Drive shaft,Cold air intake,new tires,fully adjustable shocks and struts,cobra R rims 17x9,chin spoiler,Flow master exhaust,short throw shifter,rear seat delete ( I still have the back seat it in good shape),355 gear pro 5.0 short...
I have a pony down single kit for sale. It is for a 87-93 fox body. It is a master power T70. It has the upgrade intercooler that is rated of 900 hp. The tial waste gate has a 8 PSI spring in it. It also has a tial 50mm BOV. The kit has less then 1000 miles on it. It comes with everything need...
spyder intake
I have a victor JR intake for a 302 that has been converted to EFI. Also included is the elbow, jumbo fuel rails and and the adapter. The adapter a lone are 300. I will also throw in the fuel lines I have. I am asking 600 OBO. The line and TB are not in pic because I took them at...