Recent content by 96vertsnake

I put a set of Tein springs on my daughters 08GT that I bought off of a member of this forum. The problem is the rear bottoms out going over rough roads, dips, etc. I assume it's just too low. I dont remember exactly what it measured when dropped, but I'm guessing 2 inches in the rear. I...

I just put 2010+ Gt 500 wheels on my daughters 98 GT. How do I reset the tire pressure monitoring system? I've been told it should reset itself, but it hasn't. And I've been told it needs to be done at the dealer to reset the computer to accept the newer sensors. Any help?

http://www.svtperformance.com/forums/engine-drivetrain-256/881703-fs-complete-t-56-swap-w-mcleod-twin-disc-mgw-short-throw.html I'm planning to buy this and I'm wondering if the driveshaft and transmission mount will fit in my 96. Also, will the harness work?

as the title says............

sold FRPP red spark plug wires M-12259-R464 SOLD Dyno time only on these wires. $60.00 shipped.

This came off my 96 Cobra. I made 520HP and 450TQ at 14 PSI with a T-Trim. $125.00 plus shipping Core dimensions are 11.5" tall 23.5" wide 2.5" Inlet/Outlet 31" Overall inlet to outlet.

Less than 2000 miles and in great condition. This is a VERY HIGH QUALITY piece. Sells for $475.00 on their site. $300.00 shipped Ford Mod Motor Harmonic Balancer 8 Rib, 18% OD for 2V, 3V, 4V Mustang GT & Cobra | Racing Balancer | Innovators West

Im going to put a 7 qt oil pan on my 96 Cobra. It has an oil level sensor mounted on the drivers side of the oil pan. I believe this was removed on 98 and later models. Can anyone tell me if this can be turned off in the computer or if it can be eliminated? It doesn't use a typical bung that can...

Powder coated timing chain cover sold SOLD!!! I had this cover and one other black wrinkle powder coated about 2 weeks ago. I don't need this one. It will fit 96-98 Cobra. I ran an 18% Overdrive Innovators West crank pulley so the timing sensor has been machined to allow clearance. This will...

shifter sold Pro 5.0 T-5/T-45 shifter and Steeda billet Shift knob This is off my T-45. Shifts great. $100.00 plus shipping for the Pro 5.0. SOLD!!!! $45.00 for the shift knob.

I bought this without realizing it would not work with the vortech bracket. It's got less than 100 miles on it. $275.00 shipped. Thump RRR belt tensioner for 4v PM-1003-90 Billet Aluminum Belt Tensioner with 90mm Billet Aluminum Pulley for Ford 4V Cars. - Patent Pending Heavy duty Billet...

Sold MMR IMRC deletes MMR IMRC deletes with gaskets $125.00 plus shipping. One fuel rail hold down screw is stripped. (you can see in the close up picture.) I just moved an 1/8 inch forward and drilled and tapped new hole.

BBK Twin 65mm throttle body $175.00 plus shipping.

SOLD. seimans deka injectors $275.00 shipped Seimens Deka 60lb injectors $275.00 shipped

Sold!! Spec stage 3+ 10 spline SOLD! less than 3500 miles $150.00 plus shipping.