Recent content by 88foxbod

Looking for a power steering rack and hydroboost setup out of a terminator to go in my coyote swap foxbody. Let me know what you have!

SOLD Well, I love this car to death but I am currently in Korea for a year then Germany for 4 years. I would take it with me but it takes a whole hell of a lot to get it legal to ship and drive over there. I see a fox coupe in my future though.... So heres the list of mods all installed myself...

Doesnt matter wether it's steeda or BF. Just looking for a rear diff brace. I think i've gambled enough not having one for the past year in a half at over 500hp and tq

Went to get mine re-tuned today all to find out my actuator wasn't..... well, actuating. Anyone have a serviceable one for sale laying around?

Stock 10 Spline input shaft, removed at 30,000 miles - $80 Shipped Throttle Body and Inlet Elbow wrinkle painted black - $80 Shipped for both or make an offer separated.

I have orders to Korea with a follow on going to Spangdahlem Germany. I would love to take my Terminator and run the autobahn but shes not exactly emissions friendly. I'm trying to figure out if I can ship the car and deal with getting it ready to go while in Germany or if I have to have it...

As title says, I have a SBTB just need a plenum to match it up to. If you have gasket set as well that would be even better!

Looking for an Accufab SBTB and plenum. Doesn't matter what finish because I will be wrinkle painting it black to match the blower.

Found one right as I posted this!

I'm in the process of replacing a bent valve and it seems like theres very few places to buy internal components (MMR, Livernois) Anyone have any suggestions where to shop? Also is it possible to buy single valves anywhere? I only want to replace the one bent valve due to $$$, the shop is...

So while I was waiting for my heaton to get ported I pulled my valve covers to do some painting and discovered a rocker arm just laying in the head. After further inspection one of the exhaust valves was bent. I lucked out though, pulled the heads and everything else looks great. I have a...

I'm sure your brain is yelling YES! But my question is, I have a 2.76 upper with the stock lower putting down 15lbs. I also have a 2.93 upper with a 4lb lower sitting in my garage that I hear also puts down 15lbs. Since it's putting out the same PSI do I need a re-tune?

Deal going with rudycobra for the 4lb lower Just looking for the 3.20" Alt Pulley now, it's not too expensive but I won't be ready to do the swap for another 3 weeks anyways.

Getting a port done and going to be looking for a 4lb lower pretty soon. Anyone happen to have a 3.2' Alternator Pulley laying around youd like to sell?

Looking to trade my silver 2.76 pulley for a silver or black 2.93 pulley. Going for the 2.93 with 4lb lower setup. Edit: Forgot to mention it's a Billetflow pulley only looking to trade for another Billetflow.