I am looking for a auto conversion set up, prefer a C4/4R70/75W, and all the parts I need along with it.
Also looking for E85 conversion stuff.
Debating between a big inline pump after factory pumps or upgrading the intake pump setup to a big single (return style)
PM me what you got...
Light use 63lb injectors. 275.00 shipped $OLD
BAP 40 amp 250.00 shipped $OLD
BAS make 175.00.00 shipped
Stock Rails 75.00 shipped (100 with brand new FRPS)
[email protected]
Thanks for looking.
***still have complete trans set up for sale that needs to go!!!***
I am going to switch over to E85, and I want to make sure I have my fuel issues covered the first go around. I don't want to jump into this and find out I didn't get something that flowed enough etc etc...
Here is the mods list.
POSI ported eaton TB/PL #'s in sig
2.8 upper/4# lower (19...
I am going to switch over to E85, and I want to make sure I have my fuel issues covered the first go around. I don't want to jump into this and find out I didn't get something that flowed enough etc etc...
Here is the mods list.
POSI ported eaton TB/PL #'s in sig
2.8 upper/4# lower (19...
FS: (feeler) Compete T56 + fuel stuff
Looking to sell my T56 setup, its going to be complete from flywheen to drive shaft which is also for sale.
Trans has 5K on it.
Clutch is stock 10 spline with same miles. Holds great no issues with slip at all. Driveshaft is steel also to fit to a 98...
So I was driving home from work and got caught in a nasty T-storm... went to go start the car for work and noticed the check engine light was on... got to work and used the Xcal to see what the codes were...
P-0138 High voltage 02
P-2195 ?
P-2196 ?
I am curious how much the fuel is starved from the injectors on a 100-150 shot when tapping the shrader valve???
I am using stock fuel rails... i do have a BAP. I am going to spray as much as possible, and see what happens.
Can someone design a badge to put on our Eatons that were ported by POSI?
Can someone design a Tshirt as well...
Thanks!!!
Now lets see what you guys can come up with!!!!:beer:
I am looking for a pair of 15x10's standard ford bolt pattern, with a 5.5' back spacing...
Please let me know what you have!!!
I need to do something pretty quick!