01yellercobra's latest activity

Just wanted to say hotcobra03 called it in post 3. I usually pull the blower and lower intake together. It's just easier IMO. If the...

In the words of a certain dad rock band....."One step closer...."

I've already confirmed that the high-speed setting of the fan works if jumpered directly to the battery. I've also already confirmed...

I don't remember if the engine will spin over without the ECU in place, but if it will you can always do a compression check while...

At this point I'd jump the fan from the battery. Make sure the high side works. If that's good then I'd let the engine idle up to temp...

Is this to replace the Viper or in addition to it?

Hopefully the next step is deciding on what color...

The correct way would be to use a torque wrench to check the preload by spinning the pinion as you tighten it. But you have to pull the...

I remember that happening. I didn't remember his screen name. It was an eye opening thread.

That is the first owner not the guy who I bought it from.

I don't remember details, but the low speed signal is reversed. Meaning it applies a signal to the low speed relay to turn it off. Ford...

Post 11 says Hone03. It seems @HVACdude knows who he is.

You can drop the center section by itself. If you have the original brace that runs under the pinion I think you can pull it without...

Thank the heavens my blow up doll Tiffany never talks back and is always there for me!!

I snagged the plug for mine from a Crown Vic in the junk yard. If there are any still in there.