01vert's latest activity

I can see the female plug being able to be found as there are plenty of returnless cars in the Ford lineup. My concern is the female...

I would appreciate the write up on wiring the dual FPDM as well.

drill a couple small holes on the thermostat skirt to let any trapped air past when vacuum bleeding. FYI usuallly a smal bubble...

You answered your own question if you have power on the wiring harness at the pump hat and applying power at the pump that runs. The...

Best improvement for handling before you tear into the IRS is to add full length subframe connectors. What is the purpose or intent...

Do you hear the pump prime when you turn the key? I always wait till the prime stops and then turn the key the last bit to engage the...

I ran out of pump at 450 using a DW300 which is supposed to be 340lph. I would not expect a 260 ish pump to carry 450hp. You using...

Please tell me that was an attempt at a joke…. It’s a sales display. Private stalls there. The public toilets even have a music...

OEM ford

Go look at the old gun debates on this stuff. It ended up being mostly vegetable or coconut oil iirc

You have 260 lbs of 9mm in your spare tire well?

Forgot to mention start looking through old posts here about the swap and the mach 1 forum had a ton of posts on it too iirc.

You have all the front accessories from the 03 motor? Alt and bracket, water pump, pulley bridge etc? you could run the same tank but...

If you use the original dip stick the oil will be below the seam where the pan and block meet and below the crank. Our motor has the...

Could you list the things you would do differently? It would be nice to see the issues based on your experience. Hopefully doing the...