Base E85 mods 04 cobra

Mustangfan0211

NO IT'S NOT A WRAP !
Established Member
Joined
Feb 16, 2015
Messages
90
Location
central Jersey
Hi ive been searching the forms and havent found exactly what im looking for, what is the most budget friendly way to run e85 on a pullied 04 cobra and with budget in mind what pumps injectors do you guy suggest etc... thank you
 

MG0h3

Well-Known Member
Established Member
Joined
Jul 23, 2014
Messages
13,685
Location
El Paso, TX
Ill recommend what I did because Im a tight a$$ but I wont cheap out if itll cause me more work later or not be something solid to build on. You are NOT going to want to have to rerun or configure your lines later.

I used a vendor here and we pieced together components that is similar to the FORE level 1E kit.

465s
8 feed/return
stock rails (cost is the same to do them now or later but id have to pull the blower to install them so I didnt do it)
regulator
2 8$ relays from summit
hobbs switch

I already had the injectors so add that cost in. Think I spent like 1250.
 

BLOWN9646

E85 COBRA
Established Member
Joined
Apr 12, 2006
Messages
2,223
Location
N IL
Id use either two 340lph DeatshWerks pumps or two AEM 320lph pumps, modified fpdm, and 80lb injectors.

This, except you don't need 80's...even for a ported car.

Edit: also run #8 wire to fuse box for battery
 
Last edited:

toby1234

Member
Established Member
Joined
Jan 23, 2012
Messages
449
Location
Los Angeles
Would a single Walbro 400 lph pump be enough for a car like that? Im doing a swap into a 69 mustang and I'll be running a single pump set up. Return system. Should be similar to OP's car in that its just pullied.
 
Last edited:

Users who are viewing this thread



Top